ULTRA CHORUS UC200

Ultimate Stereo Chorus Eects Pedal

Thank you for showing your condence in us by purchasing the BEHRINGER ULTRA CHORUS UC200.

This ultimate eects pedal is designed to deliver super-thick chorus with unbelievable stereo eect.

Thanks to its high-performance features you’ll have full parameter control for absolute exibility and

limitless creative options.

The chorus eect slightly detunes the original signal. A very pleasant detune eect is created in connection

with the pitch variation. The chorus eect is used often and quite extensively used for dispersing signals.

1. Controls

(6) Use the footswitch to activate/deactivate the eect.

(7) Use this ¼" TS IN connector to plug in the instrument cable.

(8) The two ¼" TS connectors OUT A and OUT B send the signal to your amp. Use both connectors if

you want to achieve full stereo chorus eect. For mono use just plug in OUT A.

Use the DC IN connection to plug in a 9 V power supply (not included).

The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,

press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.

(5)

(1)

(6)

MUSIC GROUP (MUSIC-GROUP.COM). ALL TRADEMARKS ARE THE PROPERTY OF THEIR RESPECTIVE OWNERS. MUSICGROUP ACCEPTS NO LIABILITY FOR ANY LOSS

WHICH MAY BE SUFFERED BY ANY PERSON WHO RELIES EITHER WHOLLY OR IN PART UPON ANY DESCRIPTION, PHOTOGRAPH OR STATEMENT CONTAINED HEREIN.

COLORS AND SPECIFICATIONS MAY VARY FROM ACTUAL PRODUCT. MUSIC GROUP PRODUCTS ARE SOLD THROUGH AUTHORIZED FULLFILLERS AND RESELLERS

ONLY. FULLFILLERSAND RESELLERS ARE NOT AGENTS OF MUSICGROUP AND HAVE ABSOLUTELY NO AUTHORITY TO BIND MUSICGROUP BY ANY EXPRESS OR

IMPLIED UNDERTAKING OR REPRESENTATION. THIS MANUAL IS COPYRIGHTED. NO PART OF THIS MANUAL MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM

OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY PURPOSE, WITHOUT THE EXPRESS

WRITTEN PERMISSION OF MUSICGROUPIPLTD. ALL RIGHTS RESERVED. © 2012 MUSICGroupIPLtd. Trident Chambers, Wickhams Cay, P.O. Box 146, Road Town,

Tortola, British Virgin Islands

◊ The UC200 has no on/o switch. As soon as you insert the jack into the in connector,

the UC200 begins running. When not using the UC200, remove the jack from the in

Please register your new BEHRINGER equipment right after your purchase by visiting

http://behringer.com and read the terms and conditions of our warranty carefully.

Connector ¼" TS

Impedance 500 kΩ

Connector ¼" TS

Impedance 1 kΩ

USA/Canada 120 V~, 60 Hz

China/Korea 220 V~, 50 Hz

U.K./Australia 240 V~, 50 Hz

Europe 230 V~, 50 Hz

Japan 100 V~, 50 - 60 Hz

Power connector 2 mm DC jack,

negative center

Battery 9 V type 6LR61

Power consumption 30 mA