ADDAC System ADDAC810 Assembly Manual

Type
Assembly Manual
February.2017
ADDAC810 Assembly Guide
ADDAC SYSTEM page 2
Unpack and separate all kit parts
ADDAC810 Assembly Guide : Prepare panel
ADDAC SYSTEM page 3
Locate the front panel, earth connector and short wire. Strip about 1cm of of the wire, place the earth
connector on the panel wrapped the stripped wire around the connector and use the washer and nut to
hold it against the panel. Tighten the nut and connector.
ADDAC SYSTEM page 4
ADDAC810 Assembly Guide : Front pcb and panel
Locate the front pcb
Locate the front pcb and the female headers, solder both at each end of the pcb
Turn the pcb around and place the pot, 2 leds, 2 rca connectors and 2 jacks
Insert the front panel and screw the pot and jack nuts
You can now solder all parts to the pcb.
TIP: When soldering the RCA connectors pull them as close to the panel as possible.
This will allow the RCA jack to go all the way in when plugged in.
ADDAC SYSTEM page 5
After soldering all parts, strip the loose end of the short wire insert and solder it to the pcb Earth hole
Insert 2 of the 6mm screws and tight them to the spacers
ADDAC810 Assembly Guide : Front pcb and panel
ADDAC SYSTEM page 6
ADDAC810 Assembly Guide : Back pcb and final steps
Pick the back pcb, place and solder the male headers to each end of the pcb
Place the IDC power connector in the back of the pcb and solder it
Attach both pcbs and place the last 2 screws to fix both pcbs together
Attach the Knob to the potentiometer shaft and you’re done!
ADDAC810 ASSEMBLY GUIDE
For feedback, comments or problems please contact us at:
February.2017Revision.01
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

ADDAC System ADDAC810 Assembly Manual

Type
Assembly Manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI