Unbranded PPH1SD Product information

Type
Product information

This manual is also suitable for

¢710583,¤
WIRING DIAGRAM
Convertible Packaged Heat Pump 208/230 Volt Single Phase 60Hz
1. Disconnect all power before servicing.
2. For supply connections use copper conductors only.
3. Not suitable on systems that exceed 150 V to ground.
4. If any of the original wire as supplied with the furnace must be replaced, it must
be replaced with wiring material having a temperature rating of at least 105°C.
5. For supply wire ampacities and overcurrent protection, see unit rating plate.
1. Couper le courant avant de faire letretien.
2. Employez uniquement des conducteurs en cuivre.
3. Ne convient pas aux installations de plus de 150 V
a la terre.
7105830
NNOTES:
DEFROST BOARD OPERATION:
CLOSES DURING DEFROST. RAITNG: 1 A MAXIMUM
OPENS DURING DEFROST. RATING: 2 HP AT 230 VAC MAXIMUM
CLOSED WHEN “Y” IS ENERGIZED. OPEN WHEN “Y” IS DEENERGIZED.
PROVIDES “OFF” DELAY TIME OF 5 MIN WHEN “Y” IS DEENERGIZED.
WITH DFT CLOSED AND “Y” ENERGIZED, COMPRESSOR RUN TIME IS ACCUMULATED.
OPENING OF DFT DURING DEFROST OR INTERVAL PERIOD RESETS THE INTERVAL TO 0.
1
2
3
4
C
R
S
CHF
E
DFTR
W2 0 Y C T2 T1
DF2
DF1
CY0W2RE
PRESSURE
SWITCH
(IF EQUIPPED)
TO 208/230 VAC
POWER SUPPLY
BLOWER
MOTOR
T1
T3
T4
T2 G
N
L
C
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
1
8
7
6
5
4
3
2
1
9
8
7
6
5
4
3
2
1
9
T5
DEFROST
SENSOR
COMPRESSOR
CONTACTOR
OUTDOOR FAN
MOTOR
COMPRESSOR
DUAL CAPACITOR
HEATER
PLUG
REVERSING
VALVE
SOLENID
3 AMP
FUSE
DEFROST
CONTROL
BOARD
TO INDOOR THERMOSTAT
TO DISCHARGE
AIR SENSOR
BLOWER
RELAY
TRANSFORMER
C
R
S
L2 L1
T1T2
13
56
24
24V
COM
208V
240V
ECONOMIZER JUMPER
HARNESS ASSY
9-WIRE
GB
ECONOMIZER
PLUG
ECONOMIZER
PLUG
BROWN
WHITE
WHITE
BLACK
RED
BLUE
YELLOW
YELLOW
RED
RED
BLUE
BLACK
GREEN
ORANGE
GREEN
GREY
GREEN
WHITE
WHITE
WHITE
BLACK
BLUE
BLACK
BLACK
BLACK
BLACK
BLACK
ORANGE
WHITE
WHITE
RED
RED RED
BROWN
YELLOW
YELLOW
YELLOW
GREY
GREEN
BLUE
BLACK
YELLOW
ORANGE
ORANGE
GREEN/YELLOW
ORANGE
BLUE
BROWN
RED
RED
RED
RED
RED
Legend
Field Wiring
Factory Wiring:
Low Voltage
High Voltage
Note: See Installation
Instructions for wiring,
application, and
information concerning
accessory Heat Kits and
other options.
  • Page 1 1

Unbranded PPH1SD Product information

Type
Product information
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI