VITAL Bluetooth® Audio Receiver Owner's manual

Brand: VITAL

Model: Bluetooth® Audio Receiver

Category: Bluetooth music receivers

Type: Owner's manual

PRODUCT OVERVIEW

Pair your Bluetooth®-enabled device and connect this receiver to your

car. Wirelessly stream music and take hands-free calls from your

smartphone or Bluetooth®-enabled device.

CHARGING

When you use this receiver for the rst time, or you haven't used it

for a long period of time, charge the battery. It will take approximately

2 hours to fully charge.

• The LED will ash red when the battery gets low

• Charge the receiver with the included USB charging cable.

Use a suitable port or 5V/1A power adapter (sold separately)

• The LED will turn red while charging, and turn OFF when charging

is complete

PAIRING

This receiver must be paired to a Bluetooth

-enabled device before you

plug it in to your car. Pair rst, then connect it to your vehicle's AUX IN.

Pairing range is approximately 10m (33ft.), and obstacles between the

receiver and the Bluetooth

device may reduce this range.

1. Turn your receiver ON by pressing the MFB button. The LED will ash

blue and red. After ten seconds, it will enter pairing mode.

2. Enable the Bluetooth

function on your device and nd and select

"VITAL 8075521" in the detected device list. Enter "0000" when

prompted for a password (If necessary). When your device is

successfully paired, the LED indicator will ash blue slowly.

NOTE: The receiver will automatically connect to your paired device on

the next use, as long as your device is ON and within range. If no

Bluetooth

connects within ten minutes, the receiver will automatically

turn OFF to save power.

HANDS-FREE CALLS

When a smartphone is paired to this receiver, you can make and receive

phone calls through this device.

• Press the MFB to answer an incoming call and press it again to end

• Press and hold the MFB button to reject an incoming call

• Double press the MFB to redial the last number called

NOTE: If music is playing and you receive an incoming call, the music

will stop. It will resume playing when the call ends.

OPERATING INSTRUCTIONS

TO DO THIS

Power ON

Press and hold the MFB.

Power OFF Press and hold the MFB.

Adjust the volume Press the +/- buttons.

Next track Press and hold the + button.

Previous track Press and hold the - button.

Bluetooth

pairing Automatically enters pairing mode when powered ON.

Answer a call Press the MFB.

End a call Press the MFB again.

Reject a call Press and hold the MFB.

PLAYBACK

1. To start playback, press the MFB. Press the MFB to pause playback.

A passenger may also play and pause the music through the

Bluetooth

-connected device.

2. Press and hold both the MFB and the + button simultaneously to

switch the receiver into standby mode.

SPECIFICATIONS

Bluetooth

V 4.0

Range 10m (33ft.)

Bluetooth

Protocol A2D v1.2, AVRCP v1.0, HFP v1.5

Mic sensitivity -42dB ± 3dB

Frequency 20Hz-20kHz

Battery 3.7V/170mAh

Playback Approx. 7 hours

Talk time Approx. 8 hours

WARNINGS

• DO NOT use this apparatus near water or moisture

• DO NOT install near any heat sources such as radiators, stoves, or

other apparatus (including ampliers) that produce heat

• DO NOT block any ventilation openings

• DO NOT install equipment in a conned space

• Clean only with a dry cloth

• Only use attachments/accessories specied by the manufacturer

• Refer all servicing to qualied personnel

8075521A

WIRELESS AUDIO RECEIVER

Instruction Manual

WHAT’S INCLUDED:

• Wireless audio receiver

• Micro USB charging cable

• Instruction manual

FEATURES:

1. Bluetooth

4.0 supports A2DP

2. Hands-free calling

3. Plug and play, no driver or software

required

4. Built-in rechargeable battery

5. Up to 7 hours of playback

COMPONENT IDENTIFICATION:

1. USB charging port

2. LED indicator

3. Volume up/Next track

4. Volume down/Previous track

5. MFB (multi-function button)

6. 3.5mm audio plug

The Bluetooth

word mark and logos are registered trademarks owned by Bluetooth

SIG, Inc. and any use of

such marks by The Source (Bell) Electronics Inc. is under license. Other trademarks and trade names are those

of their respective owners.

The Source warrants that this product will be free from defects in materials and workmanship for a period of twelve (12) months from the date of purchase. Within this period, simply take the product and your proof of

purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this

warranty.

This warranty is only applicable to a product purchased through The Source company-owned stores or participating dealers in Canada where the warranty is included with the product. While this warranty does not

confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other governmental entities in which

The Source operates. This warranty is subject to all statutory rights you may have in Canada.

Imported by:

The Source, Barrie, Ontario, Canada, L4M 4W5

Manufactured in China

www.thesource.ca

Please

Recycle

THE SOURCE - WARRANTY

INDUSTRY CANADA RSS 247

This device complies with RSS-247 of Industry Canada. Operation is

subject to the following two conditions:

(1) this device may not cause interference, and