Signature Hardware 456233 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
456233
Type
Installation guide
1Vessel Vanity Top Installation Instructions
VESSEL VANITY TOP INSTALLATION
GETTING STARTED
TOOLS AND MATERIALS:
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures and
plumbing. Signature Hardware accepts no liability for any
damage to the floor, walls, plumbing, vanity cabinet, sink,
counter top, or personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the vanity for damage. If any
damage is found, contact our Customer Relations team
at 1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
Ensure that your bathroom floor is adequately
supported, and the finished floor is level.
Ensure that there is adequate support behind the
bathroom wall before installation.
PLANNING
Use the vanity’s PDF specification sheet as a reference
when planning your layout. The specification sheet can
be found and downloaded from the product page on
our website.
Because the vanity specification measurements are
approximate and slight variations may occur, we highly
recommend performing any rough-in procedures with
the vanity on site.
Neutral Cure
Silicone Sealant
Damp Cloth
NEVER LIFT THE VANITY TOP FLAT NEVER CARRY THE VANITY TOP FLAT
2
VESSEL VANITY TOP INSTALLATION
Vessel Vanity Top Installation Instructions
STEP 1: VANITY TOP INSTALLATION
1. If replacing the top on an existing vanity, ensure that
all adhesive has been removed from where the old
counter was attached.
2. Attach a bead of silicone sealant around the top
edge of the vanity cabinet.
3. With assistance from another person, slowly and
carefully set the top onto the vanity cabinet. Once
positioned, press firmly into place. Wipe away any
excess sealant using a damp cloth.
Important: The top is fragile. Take caution when
handling, and have someone assist if needed.
4. If you are installing a side-splash and/or back-splash,
place a generous amount of silicone sealant on the
back of it and press it into place against your bathroom
wall. Fill any gaps that are left with silicone sealant.
Wipe away an excess sealant with a damp cloth.
5. For stone tops, such as marble and granite, it is
recommended that you apply a high-quality sealer to
protect from staining and discoloration. Stone sealer
should be reapplied once or twice per year, depending
upon usage.
Stone Sealer
3
VESSEL VANITY TOP INSTALLATION
Vessel Vanity Top Installation Instructions
2. Turn the sink right-side-up and position over the 2"
drain hole.
1. Carefully place your vessel sink upside down on the
counter top. Apply a generous amount of silicone
sealant to the base of the sink where it will rest on the
counter.
3. If desired, apply a continuous bead of silicone
sealant around the perimeter of the sink base for
additional stability.
Step 2: Sink Installation
4. Remove any excess sealant to complete the sink
installation.
5. Let the assembled vanity sit for 24 hours to allow all
the silicone sealant to fully dry. Once dry, proceed to
the installation of your faucet and drain.
Note: In some situations, it may be necessary to cut
the inner cabinet shelf to allow for youe drain’s P-trap.
24 hr
  • Page 1 1
  • Page 2 2
  • Page 3 3

Signature Hardware 456233 Installation guide

Signature Hardware
Brand
Signature Hardware
Model
456233
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents