Minka Group 72631-143C User manual

Brand: Minka Group

Model: 72631-143C

Type: User manual

INSTALLATION INSTRUCTIONS

For item#72631-143C (New. 12/11/2017)

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig.1

Fig. 3

PREPARING FOR INSTALLATION (Fig. 1)

1. Shut off the power at the fuse box or circuit breaker. If

necessary, remove the old fixture, including the

mounting hardware.

2. Carefully unpack your new fixture, lay out all parts on a

clear area. Be careful not to lose any small parts

necessary for installation.

3. Thread the studs (B) into the pre-drilled holes of the

circular strap (A), spaced the same distance apart as the

holes in the back plate (D).

4. Attach the circular strap (A) to the outlet box using the

mounting screws (C) (Size: #8-32N*L0.5”). The side of

the circular strap (A) marked “GND” must face out.

5. Install the glass panel (G) into fixture body (F) and

secure with the tabs provided.

CONNECTING THE WIRES (Fig. 2)

6. At this point, connect the fixture wires to outlet box wires

as shown in Fig. 2, making sure that all wire connectors

are secured. If your outlet box has a ground wire (green

or bare copper), connect the fixture’s ground wire to it.

Otherwise, connect the fixture’s ground wire directly to

the circular strap (A) using the green screw provided.

After wires are connected, tuck them carefully inside the

outlet box.

COMPLETING THE INSTALLATION (Fig. 1)

7. Align back plate (D) onto studs (B) and secure with two

ball nuts (E).

8. To prevent moisture from entering the outlet box and

causing a shortage, use clear caulking (i.e.

Indoor/Outdoor silicone sealant) to outline the outside of

fixture back plate where it meets the wall leaving a space

at the bottom to allow moisture a means to escape

(Fig.3).

9. Install the light bulbs (H) (not included) in accordance

with the fixture’s specifications. (DO NOT EXCEED

THE MAXIMUM WATTAGE RATING!!) (NE PAS

DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!)

Your installation is now complete. Return power to the

outlet box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

LA-2896E

Fig.2

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green or

Bare

Copper

(Ground)

Set# A-020

- Circular Strap

- Ground Screw

- Mounting Screw*2

CAULKING

BACKPLATE

Minka Group 72631-143C User manual

Minka Group 72631-143C User manual

Minka Group 72631-143C User manual

Related papers

Other documents