OKI C711DTN Owner's manual

Category
Print & Scan
Type
Owner's manual
SD Card Install
Installation de la Carte SD
Instalación de la Tarjeta del SD
A Instalação do Cartão do SD
C610/C711 SD Card Installation > 3
SD C
ARD
I
NSTALLATION
(C610/C711)
The optional SD card enables collating of printed pages and can
be used to store overlays and macros, fonts, and secure or
proof documents waiting to be printed.
1. Switch the printer off and disconnect the AC power
cable.
2. Press the cover release and open the printer’s top cover
fully.
WARNING!
If the printer has been powered on
recently, the fuser will be hot. This area is
clearly labelled. Do not touch.
OI
C610/C711 SD Card Installation > 4
3. Pull down the MP Tray using the depressions. Lift the
front cover release lever and lower the front cover.
C610/C711 SD Card Installation > 5
4. Loosen the screw (a) securing the right-hand side cover.
Lift the edge of the side cover slightly and pull the cover
away from the printer at the top. Lift the cover slightly
to detach it from the printer. Place it safely to one side.
a
C610/C711 SD Card Installation > 6
5. Notice that the SD card has one chamfered corner.
6. Gently push the SD card into the slot as shown.
7. Locate the retaining clips at the bottom of the side cover
into their rectangular holes near the bottom of the
printer.
C610/C711 SD Card Installation > 7
8. Close the top of the side cover up to the printer and refit
the securing screw loosened in step 4.
9. Close the front cover and the top cover, pressing down
firmly at each side to latch it closed.
10. Reconnect the AC power cable and switch the printer on.
C610/C711 SD Card Installation > 8
11. When the printer is ready, print a menu map as follows:
(a) Press the Enter button.
(b) Press the Menu down button then the Enter
button to select the Print Information menu.
(c) Select Configuration with the Enter button.
(d) Press the Enter button once more to execute the
Configuration menu.
(e) When the Configuration map is printed, press On
Line to exit the menu system. Examine the first
page of the menu map. This should now indicate
that the SD card is installed.
C610/C711 installation de la carte SD > 12
5. Remarquez que la carte SD présente un coin biseauté.
6. Repoussez doucement la carte SD dans l’emplacement,
comme illustré.
C530 SD Card Installation > 27
SD C
ARD
I
NSTALLATION
(C530
ONLY
)
The optional SD card enables collating of printed pages and can
be used to store overlays and macros, fonts, and secure or
proof documents waiting to be printed.
1. Switch the printer off and disconnect the AC power
cable.
2. Press the cover release and open the printer’s top cover
fully.
WARNING!
If the printer has been powered on
recently, the fuser will be hot. This area is
clearly labelled. Do not touch.
OI
C530 SD Card Installation > 28
3. Pull down the MP Tray using the depressions. Lift the
front cover release lever and lower the front cover.
C530 SD Card Installation > 29
4. Loosen the screw (a) securing the right-hand side cover.
Lift the edge of the side cover slightly and pull the cover
away from the printer at the top. Lift the cover slightly
to detach it from the printer. Place it safely to one side.
a
C530 SD Card Installation > 30
5. Notice that the SD card has one chamfered corner.
6. Gently push the SD card into the slot as shown.
7. Locate the retaining clips at the bottom of the side cover
into their rectangular holes near the bottom of the
printer.
C530 SD Card Installation > 31
8. Close the top of the side cover up to the printer and refit
the securing screw loosened in step 4.
9. Close the front cover and the top cover, pressing down
firmly at each side to latch it closed.
10. Reconnect the AC power cable and switch the printer on.
C530 SD Card Installation > 32
11. When the printer is ready, print a menu map as follows:
(a) Press the Enter button.
(b) Press the Menu down button then the Enter
button to select the Print Information menu.
(c) Select Configuration with the Enter button.
(d) Press the Enter button once more to execute the
Configuration menu.
(e) When the Configuration map is printed, press On
Line to exit the menu system. Examine the first
page of the menu map. This should now indicate
that the SD card is installed.
C530 installation de la carte SD > 34
3. Tournez la vis de verrouillage (a) dans le sens inverse
des aiguilles d'une montre et retirez le capot d'accès
intérieur (b). Mettez-le de côté, dans un endroit sûr.
4. Remarquez que la carte SD présente un coin biseauté.
b
a
C530 installation de la carte SD > 36
7. Replacez le couvercle d'accès et verrouillez-le.
8. Rebranchez le câble secteur et mettez l’imprimante sous
tension.
a
b
C330/C530 a instalação do cartão do SD > 46
7. Recoloque a cobertura de acesso externa e encaixe-a
para fechá-la.
8. Reconecte o cabo de alimentação e ligue a impressora.
a
b
58404601 my.okidata.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48

OKI C711DTN Owner's manual

Category
Print & Scan
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI