1. Using a Phillips
screwdriver
(not provided)
undo the locking
screw and
remove the
battery
compartment
door from the
sound box.
2. Install 3 AG13/
LR44 1.5 V
batteries
(included) in the battery holder.
Be careful to align the positiv
e (+)
and negative (-) polarities with the
corresponding markings inside the
batter
y holder
.
3. Reinstall the battery compartment
door and re-tighten the locking screw.
The Spider-Man™ Bop Bag will take all the kicks and
punches that you can dish out and it bounces back for more!
+
–
IMPORTANT BATTERY INFORMATION
• Batteries should always be replaced by
an adult.
• Do not mix old and new batteries.
•
Do not mix alkaline
, standard
(carbon-zinc), rechargeab
le or different
types of batteries.
• Do not use rechargeab
le batter
ies
.
• Non-rechargeable batteries are not to
be recharged.
• Rechargeable batteries are to be
removed from the toy before being
charged (if removable).
•
Only batter
ies of the same or equiv
alent
type as recommended are to be used.
• Batteries are to be inserted with the
correct polar
ity
.
•
Exhausted batter
ies are to be remo
v
ed
from the toy.
• The supply terminals are not to be
short-circuited.
• Do not dispose of batteries in fire or
w
ater
.
Battery
Compartment
Battery
Compartment
Door
2
Three
AG13/LR44
1.5 V
Batteries
(included)
3
Contents:
• 1 Spider-Man™ Bop Bag with Sound Effects
• 1 56 cm x 160 cm Floor Mat
• 1 Instruction Sheet
BATTERY INSTALLATION
Sound
Unit
Rear View
Front View
Floor Mat
1
TM
TM
TM
If Bop Bag
will not fill up.
If Bop Bag f
alls o
v
er
and sta
ys do
wn.
If Bop Bag
deflates
.
- Check to ensure that you are pinching the air nozzle firmly. You should be able to hear the air inflating
the bag and see the bag increase in size as air is added.
- If air is entering bag and Bop Bag still does not fill up, check to ensure that there is no hole in the bag.
This can be checked by immersing the bag in water and seeing if air bubbles are exiting the bag from
an
y point. If so, holes can be repaired by covering them with duct tape.
-
Chec
k base of Bop Bag to ensure that no water is leaking from the bottom.
A properly filled Bop Bag
should retur
n upr
ight when punched.
-
Chec
k to ensure that there is no hole in the bag. This can be chec
ked by immersing bag in water and
seeing if air b
ub
b
les are e
xiting the bag from any point. If so, holes can be repaired by covering with
duct tape
.
1. Locate and open air nozzle
on top of base. Pinch nozzle
as shown and with your
mouth, blow air into the
inflatable base.
2. When the base is properly
inflated, replace the air
nozzle cap.
1
2
13
A
DD WATER TO LOWER BASE
TROUBLESHOOTING
ADD AIR TO UPPER BASE
1. Locate and open air nozzle
on upper bag. Pinch nozzle
as shown and with your
mouth, blow air into the
inflatable upper bag.
2. When the upper bag is
properly inflated, replace
the air nozzle cap.
1
2
ADD AIR TO UPPER BOP BAG
1. Unfold Heavy Bag and
place flat on the floor.
2. Locate base filler area
and remove the filler cap.
3. Remove filler plug.
4. Add water to base, being
careful not to overfill it.
5. Add filler plug.
6. Re-install filler cap.
NOTE: Weight of water
s
hould be 5.5 kg
.
2
4
5 6
TM
Some segments of the exercise or movements can be strenuous to some
individuals. It is important to ensure your child does not have any medical
or physical conditions that would cause illness or injury. When in doubt,
please consult a ph
ysician.
• ADULT SUPERVISION REQUIRED: Children should only attempt moves
shown in the video within their limitations and capabilities and it is
required that an
y jumps or e
xtreme mo
v
ements be monitored or assisted.
• The mat supplied with the product should be set up on a non-slip surface.
Where used on smooth surfaces such as wood or ceramic, a non-slip
liner or two sided tape is recommended to be placed beneath the mat.
•
The mat should be set up in open spaces free of clutter
, faraway from
walls, tables, chairs, etc. as many of the moves involve balance and
jumping.
WARNING:
MARVEL, Spider-Man and the distinctive likenesses thereof are trademarks of Marvel
Characters, Inc., and are used with permission. Copyright © 2007 Marvel Characters, Inc.
All rights reserved. Licensed by Marvel Characters, Inc. www.marvel.com.
T
oy concept developed in association with Bella Products Pty
. Ltd. Master Moves
and Spin Master logo are trademarks of Spin Master Ltd. Conforms to product safety
standards ASTM F963-03, EN71 regulator
y requirements. ADUL
T
SUPERVISION REQUIRED. Products and colours may vary.
Please retain this information for future reference.
Please remove all packaging material before giving to children.
MADE IN CHINA.
#20007450, #20009171 REV 0 GBL English
Spin Master Ltd., 450 Front Street W
est, T
oronto, ON M5V 1B6 Canada.
Customer Care: 1-800-622-8339 www.spinmaster.com/customercare
Fax: 416-364-8005 Web: www.spinmaster.com Email: toys@spinmaster.com
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221, USA.
Spin Master T
oys Far East Limited. Rm #1113, 11/F, Chinachem Golden Plaza,
77 Mody Rd., Tsimshatsui E., Kowloon, HK.
Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks, SL8 5AJ,
United Kingdom After Hours Ser
vice: 0870 850 8408
Spin Master France - 36 rue de Silly - 92100 Boulogne Billancourt - France.
Ser
vice Après-V
ente - Numéro vert : 0800 803 355 ou E-mail : Jouets@spinmaster
.com -
Site internet : www.spinmaster.fr <http://www.spinmaster.fr/>.
/