Spotlight Tripod Lamp
Assembly Instruc�ons
1)
using the long bolt, split washer and
cap nut.
2) Insert the lower half of the leg into
the top half and screw the threaded rod
into place. Add the rubber washer, metal
washer and wing-nut in order, to the
threaded rod. Extend all three legs into
at equal level.
3)
wing-nut.
4) Using the short bolt, split washer and
wing-nut connect all three support arms.
5) Fit the lamp body to the tripod by
the top of the tripod.
6) Tighten the set screw on the tripod
7)
toggle clip on the lamp body, and hinge
the front down. Screw the bulb into the
holder, close the front and latch the
toggle clip. If replacing the bulb allow at
least 10 mins for the bulb to cool. Always
unplug the lamp before removing or
installing a bulb.
Care and Use
Before cleaning disconnect the lamp from the mains at the wall.
Safety
WARNING! The lamp will become hot during use. Avoid contact
with the hot lamp, especially direct contact with the bulb. For
and in place before use.
Set-up and Assembly
Tools Required: Cross head screwdriver, 10mm Spanner
before use.
Disposal
disposal of Waste Electrical and Electronic Equipment according to
household waste.
If the lamp can not be used any more, each consumer is obligated by law to
dispose of old devices separately from household waste, e.g. at a local
replaced; if the cord is damaged, the luminaire shall be destroyed.
on the environment or human health, due to the presence of any
x3 long bolt
x3 threaded rod
x3 rubber washer
x3 metal washer
x3 cap nut
x4 split washer
x1 set screw
x4 wing-nut
x1 short bolt