Gas
Brake
E-brake
BH8
INSTALLATION INSTRUCTIONS
BRAKE CONTROL HARNESS
51446 & 51447 APPLICATIONS
Scan for helpful
installation tips
NOTICE
All steps must be followed to ensure the CURT brake control
harness will function properly. Once installed, test for proper
function by following the brake control unit instruction manual.
Make Model
Dodge Durango (w/ factor y tow package)
Jeep Grand Cherokee (w/ factory tow package)
BH8 - Under dash, to right of emergency brake pedal
Representative vehicle shown below
LOCATION GUIDE
PAGE 1 • RA • NEED ASSISTANCE? • 1.877.287.8634 • CURTMFG.COM
A B
INSTALLATION /
SAFETY INSTRUCTIONS
Step 1
Locate the felt liner under the dash, to the left of the steering
column. Remove the two plastic fasteners securing the liner (A).
Behind the felt liner, locate the vehicle brake control harness
connector. It will be attached to the top of a junction box (B).
The connector will be similar to that on the CURT brake control
harness.
Step 2
Insert the connector on the CURT brake control harness into
the vehicle connector. Make sure the connector is fully inserted
with locking tabs in place.
Step 3
Insert the brake control harness's black connector into the
brake control's quick plug connector. Secure the brake control
harness with the provided cable ties, avoiding any pinch points.
Step 4
Complete the installation using the brake control instructions.
Mount the unit as directed and perform test procedures as
instructed in the brake control user manual.
CURTMFG.COM • NEED ASSISTANCE? • 1.877.287.8634 • RA • PAGE 2
-
1
-
2
CURT 51447 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
CURT 51438 Brake Controller Harness User manual
-
CURT 51439 User manual
-
CURT 51373 User manual
-
-
CURT 51436 User manual
-
-
-
-
-
