In the unlikely event that your Lifemax product develops a
manufacturing fault, it is covered by a one year return to base warranty
when you return this card.
Your warranty is only valid with the original receipt, please ensure you
keep this safe. The warranty runs from the date of purchase.
If your product develops a defect during the warranty period, please
call 0165 8742 for further advice. If requested, please securely
pack your item and return enclosing your contact details, your proof of
purchase and fault details.
We will, at our discretion, repair or exchange the item in line with
warranty legislation. Where no proof of purchase is provided, or the
product is outside the warranty period, repairs/replacements will be
oered at cost to the customer.
Name
Address
Telephone
Email
Retailer
Date of Purchase
We would like to keep you up to date with other helpful products. If you would rather we did not, please tick here.
Warranty Card
1614 - Clear Time Day Date Wall Clock
Lifemax Limited
1 Pipers Court, Thatcham,
RG19 4ER. United Kingdom.
www.lifemaxuk.co.uk
T: 01635 874323
1614 - Clear Time Day Date Wall Clock
Our smart day-date wall clock sports an oversized 30cm face
with clear numbers and distinct hands, making it easy to read
from anywhere in the room. The uncluttered digital display
shows the Day, Date and Month in UK format, making it a great
aid for anyone living with dementia.
Instructions
LCD Display
Remove the battery cover on the rear of the clock and insert
1 x AAA battery ensuring the correct polarity has been observed.
Replace the AAA battery cover.
To enter the set mode, hold the SET button to until the year
starts to flash. Use the UP key to change the year and confirm by
pressing the SET button. The display will move on to the month.
Repeat the above process for the month and date, 12/24 hour
mode, hour and minute. The LCD display will return to its default
display after 20 seconds of inactivity.
It is important to set both the date and time for the calendar to
work. We recommend using 24 hour mode to ensure the time is
set correctly to AM or PM.
Analogue Display
Insert 1 x AA battery in the open slot ensuring the correct polarity
has been observed.
To set the analogue clock hands, rotate the knob on the reverse
of the clock until the clock hands show the correct time.
This product uses 1 x AA and 1 x AAA size batteries (not included) - Alkaline manganese batteries recommended
- Follow the instructions above to fit or replace the batteries. - Use only designated battery type. Do not use
re-chargeable batteries. Do not mix battery types - Read instructions carefully and install batteries correctly
observing the polarity (+ -) sign to avid leakage. - Always replace sets of batteries at the same time. Do not mix
old and new batteries. - Do not attempt to recharge non-rechargeable batteries. - Remove batteries from the
product when it will not be used for an extended period of time to avoid leakage. - Remove exhausted battery
to avoid leakage. - Do not short out battery contacts. - Do not dispose of batteries in fire. - Do not immerse
electrically operated products in water or other liquid. - Wipe clean only.
/
