Initializing
¨
Recalling a preset (Preset mode)
Switching between presets 1-4
¦
NOTE
In Preset mode turning each knob does not change reverb
sounds. Only the reverb sound in the preset is output.
Switching 1-128 presets via MIDI
¦¤¤
¤
©
LED on, LED off.
§
Confirming the position of each knob stored in
the preset
¨
Changing/writing preset contents (Edit mode)
When the LED above the EDIT switch illuminates, the
AMBI SPACE is in Edit mode. Edit mode is used to
change/write preset contents and pressing the EDIT
switch puts the AMBI SPACE in this mode.
When the unit is put in Edit mode from Manual mode
¨
¨
When the unit is put in Edit mode from Preset mode
¨
¨
Configuring MIDI settings
Changing MIDI reception settings
¤¤
Setting MIDI receiving channels
¤¤
¤¤
¤¤¦
¤¤¦
¤¤¤¤
Receivable MIDI messages
Correspondence between presets and MIDI program change numbers
Correspondence between parameters and MIDI
control change numbers
PRESET-1 001
PRESET-2 002
PRESET-3 003
PRESET-4 004
PRESET Number Program Change Number
Correspondence between MIDI receiving channels and PRESET LED indications
PRESET-1 LED PRESET-2 LED PRESET-3 LED PRESET-4 LED MIDI Channel to be set
× × × × MIDI Channel 1
× × × MIDI Channel 2
× × × MIDI Channel 3
× × MIDI Channel 4
× × × MIDI Channel 5
× × MIDI Channel 6
× × MIDI Channel 7
× MIDI Channel 8
× × × MIDI Channel 9
× × MIDI Channel 10
× × MIDI Channel 11
× MIDI Channel 12
× × MIDI Channel 13
× MIDI Channel 14
× MIDI Channel 15
MIDI Channel 16
PRE DELAY 92 0-127
DECAY 93 0-127
TONE 94 0-127
MIX 95 0-127
MODE 96 0-127
EFFECT ON/OFF 65 off=0, on=127
Controls MIDI CC Numbers Value Range