Winegard® Hitch Mount HMK-300 Quick Start Guide
SETUP
For help, send an email to help@winegard.com or call 1-800-788-4417.
2452494 Rev7/22
For more
product details,
visit Winegard’s
website.
Winegard Company 2736 Mt. Pleasant St. | Burlington, IA 52601
Printed in U.S.A. © 2022 Winegard Company
1 SLIDE hitch mount into vehicle/RV hitch or multi-
use mount (sold separately), aligning mounting holes
on left side (a). Round tube mounts vertically, with
two thumb bolts on right side (b).
2PLACE washer over thumb bolt, thread onto hitch
mount and hand tighten (left side of mount). You are
now ready to install TPLE-15 (not included).
WARNING:
This product is not intended to be used with any other
items. Failure to follow may cause damage or injury.
3 SET-UP telescoping pole as instructed in TPLE-15
quick start guide. Tighten bolts to pole until snug (b).
If over-tightened, damage to pole will happen and/
or it will restrict raising and lowering of telescoping
pole (c).
WARNING:
INSTALLATION OF THIS PRODUCT NEAR POWER
LINES IS DANGEROUS. Watch out for overhead power lines.
Check the distance to the power lines before you start installing.
Winegard recommends you stay a minimum of twice the length
of the antenna plus the length of the mast from all power lines.
Failure to properly secure pole in hitch mount may result in
serious injury or death. This product is intended to be used with
Winegard Approved product only. Any other product will void
Product Warranty.
1 REMOVE: Lower and remove pole as instructed in
TPLE-15 quick start guide.
2REMOVE thumb bolt and washer (a) from vehicle/
RV hitch and slide out hitch mount. Thread washer
and thumb bolt back onto hitch mount for storage.
WARNING:
Pole must be removed prior to vehicle/camper
moving. Failure to do so may cause damage or death.
CONTENTS:
• hitch mount
• 3 thumb bolts
• washer
c
a
b
Works with Winegard approved products
and accessories. For complete list see
Winegard website. Use with any other
products will void Product Warranty.