Ibico ibiMaster 200 User manual

Page is loading ...

ibiMaster 200



Waste Tray

• The waste tray is located under the machine, at the rear.

Empty the tray on a regular basis, to prevent clogging and

possible damage. (fig 8)

Comb and cover storage

• The ibiMaster 200 has built in storage for combs and

binding covers. Keep them stored in the machine so that

you do not waste time looking for suitable supplies with

which to bind. We recommend that you use IBICO or GBC

combs and covers, for excellent results.

Binding the document

Place the comb on the comb opener with the fingers

upwards. (fig 4)

Push the punch handle back, until the comb opens

sufficiently to be able to insert the document (fig 5)

Feed the document, front cover facing downwards, onto

the open comb fingers (fig 6)

Pull the punch handle towards you, until the comb is

closed once again (fig 7). The Presentation is now

complete. Remove the document by simply lifting it

upwards.

1

2

3

4

Determine the correct comb size

• For good results it is best to use a comb with a diameter

that is similar to the thickness of the document to be bound.

In order to determine the correct comb size, place the

collated document with its covers into the binder sizer

(fig 3).

• Slide the indicator across until it touches the document. It

will give you the measurement for the recommended comb

to use.

Punching the document

• Collate the document and insert the edge to be bound into

the punch throat, maximum 20 sheets at a time. Jog the

sheets until they are flush against the edge guide and the

back wall of the punch throat (fig 2, A).

• With the paper resting on the punching platform, pull the

punch handle towards you (fig 2, B). Then, return the punch

handle to its original position and remove the paper from the

punch throat.

• Repeat this operation until the whole document is punched.

• If punching PVC covers, insert no more than two covers at

a time as this material, in large quantities, could cause jams

or excessive wear.

Set up

• Unpack carefully and place the ibiMaster 200 on a flat

surface, ideally 74cm from the floor. When lifting the

machine, lift from the bottom. Do not carry the machine

by the handle.

Edge Guide adjustment

• Ensure that the Edge Guide (fig 1) is set to ‘A4’.

ibiMaster 200



Problems getting started

• With over 50 years experience in making binding machines,

we know that when a machine is used for the first time,

punching errors can occur. In order to get best results, we

recommend that a ‘practice punch’ should be carried out.

Quickly you will see how easy the machine is to use and you

will not damage any crucial documents. If however you do

experience problems, it may be for the following reasons:

Symptom Cause Corrective action

The punch holes are not parallel with

the edge of the paper

The end punch hole is over the end of

the paper

Paper chips are blocking the throat area

Paper was not inserted flush against the

back wall of the punch throat

The edge guide is not set to the same

size as the paper or the paper is not

flush against the edge guide

Insert paper into the throat area and

slide the paper from left to right, to

clear the blockage

Insert paper fully into the punch throat,

until the paper stops going in

Ensure that the edge guide is on the

correct paper setting and that the paper

is flush against it

If you have persistent problems with the

ibiMaster 200, please contact your dealer.

Specifications

Maximum paper height

Number of punch dies

Punch Capacity

Punch Capacity per hour

(approximate)

Bind Capacity

Bind Capacity per hour

(approximate)

Net weight

Dimensions (W x H x D)

A4, 297mm

21

20 sheets, 80gsm paper

5000 sheets

500 sheets, 51mm

200 books

8.7kg

455mm x 185mm

x 435mm

Guarantee

Operation of this machine is guaranteed for one year from

date of purchase, subject to normal use. Within the guarantee

period, GBC will at its own discretion either repair or replace

the defective machine free of charge. Defects due to misuse

or use for inappropriate purposes are not covered under the

guarantee. Proof of date of purchase will be required. Repairs

or alterations made by persons not authorised by GBC will

invalidate the guarantee. It is our aim to ensure that our

products perform to the specifications stated. This guarantee

does not affect the legal rights which consumers have under

applicable national legislation governing the sale of goods.

Page is loading ...

GBC Office Products

5700 Old Orchard Road

Skokie, IL 60077

USA

www.gbc.com

Ibico ibiMaster 200 User manual

Related papers

Other documents