17
Keep the drainage hole clean so that the defrosted water flows down
to the evaporating tray smoothly. Once jammed, you can remove the pin
in the drainage hole and clean it. Then put it back.
Freezer compartment
Before defrosting - unplug the power plug, open the door and take out the
food and drawers in thefreezer, you can store the food in the refrigerator
temporarily.
Defrosting – Use the defrosting board to scrape off the frost on the
inside wall of the freezer and on the surface of th
e shelf evaporator.
Wipe the defrosted water with a cloth and then dry.
After defrosting – turn on the power supply.
Drainage pipe
Note:
Ice making
1. Fill the ice tray with water to 4/5 of its capacity
and place it inti the freezing compartment.
2. Twist the both sides of the ice tray so as to
remove the ice tray so as to remove the ice cubes easily.
Fill with potable water only.
Defrosting board
Tip :
To remove ice cubes easily, run water on the tray before twisting.
Multi-Use compartment
When the temperature in the Multi-Use compartment is set lower than 0 °C,
it is normal that frost and ice appears around the cooling room;
When the temperature is set higher than 0
°C , the frost will gradually melt.
As the refrigerator operationes,the moisture from foods
or in the air may be frosted on to the inner part of the
refrigerator and the surface of evaporator.
Too thick frost will affect the operation of the
refrigerator,so regularly defrosting is necessary.
Usually defrosting is necessary when the
thickness reaches 5 mm.
Refrigerator Compartment
Defrost
Defrosting automatically,moisture on the inner side runs into the drip tray
through the drain pipe.
The heat generated by compressor eveaporates the water automatically.