2. Minebea Intec
  3. Add info option Y3

Minebea Intec Add info option Y3 Owner's manual

  • Hello! I've reviewed the additional information document for the Minebea Intec PR 5900 with the Y3 option. This document outlines important safety instructions, like restrictions on fuse replacements, and mentions the certifications for use in explosive environments. I can assist with questions related to the document or device.
  • Is fuse replacement in PR 5900 allowed?
    Where can I find additional documents?
    What certification is required for load cells and weighing platforms?
Y3 option for PR 5900
Additional information
Original additional information 9499 059 59300 Edition 2.3.0 01/25/2018
Minebea Intec GmbH, Meiendorfer Str. 205 A, 22145 Hamburg, Germany
Phone: +49.40.67960.303 Fax: +49.40.67960.383
Foreword
Must be followed!
Any information in this document is subject to change without notice and does not represent a commitment on
the part of Minebea Intec unless legally prescribed. This product should be operated/installed only by trained
and qualied personnel. In correspondence concerning this product, the type, name, and release number/serial
number as well as all license numbers relating to the product have to be cited.
Note
The product is partially protected by copyright. It may not be changed or copied, and it may not be used without
purchasing or written permission from the copyright owner (Minebea Intec). Its use constitutes acceptance by
you of the above-mentioned provisions.
Table of contents
1 General information.............................................................................................................................2
2 Documentation on the CD included ...................................................................................................... 3
3 Appendix .............................................................................................................................................4
3.1 Certicates/control drawing.....................................................................................................................................4
Y3 option for PR 5900 Table of contents
EN-1 Minebea Intec
1 General information
NOTICE
Warning of personal injury and/or property damage.
Except for the mains fuses replacement of fuses in PR 5900 with Y3 option is not
allowed!
-It is essential to observe the control drawing in the appendix (see Chapter 3.1)!
-The PR 5900 is only certied by FM Approvals and suitable for use in explosive
atmospheres in Canada and the USA with the Y3 option; see Chapter 3.1 in the
appendix.
-Connected load cells or weighing platforms must be certied for use in Ex area.
Observe the control drawing in the appendix (see Chapter 3.1), especially the
permitted cable length!
Note:
Please notice that the FM-Extension boards (see picture below) are part of the device
and must not be removed!
Y3 option for PR 5900 1 General information
Minebea Intec EN-2
2 Documentation on the CD included
The documents and manuals listed in the appendix (see Chapter 3.1) can be found on the
PR 5900 CD.
2 Documentation on the CD included Y3 option for PR 5900
EN-3 Minebea Intec
3 Appendix
3.1 Certicates/control drawing
Ser. no. Description Document no.
1 Declaration of conformity for Canada FM16CA0139
2 Declaration of conformity for the USA FM16US0270
3 Control drawing 2015571
The documents listed in the table can be found on the PR 5900 CD.
Y3 option for PR 5900 3 Appendix
Minebea Intec EN-4
Published by
Minebea Intec GmbH | Meiendorfer Strasse 205 A | 22145 Hamburg, Germany
Phone: +49.40.67960.303 | Email: [email protected]
www.minebea-intec.com
/