CHAPTER 2
ur SMC70032AE
RJ11 connectors, plug one side into the
all jack set up as the ADSL line and the other end in the ‘LINE’ port on the
hernet cable
you are connecting to a networking device, connect a straight-through
Ethernet port. If connecting directly
an initial setup other than the default configuration is required, you will need
s RS-232C port (a DB9 Male port
lug the power cord into the wall and then connect it to the power adapter unit.
will need to connect the 6-pin DIN
Figure 1-1 and Figure 1-2 show how to connect SMC70032AE
ith cables)
Connecting yo
① Step 1: Plug in the phone line
Using a standard telephone cable with
w
back of the SMC70032AE.
② Step 2: Plug in the Et
If
Ethernet cable to the SMC70032AE “LAN”
to your PC, the cable must be a crossover Ethernet cable.
③ Step 3: Connect the console link
If
to use the serial cable to connect the PC’
usually assigned to COM1 or COM2) to the “CONSOLE” port on the back of the
SMC70032AE modem (a DB9 Female port). Setting up the modem requires a
terminal emulation program such as HyperTerminal to access the command line
interface program of the modem. You may also use the Graphical User
Interface included on the SMC70032AE CD.
④ Step 4: Plug in the power supply
P
With the adapter now powered, you
connector from the power adapter to the corresponding “POWER” port on the
SMC70032AE.
(The following
w
4