2. Homelite
  3. a07069aa

Homelite a07069aa Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Homelite a07069aa Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Part Number 19591-A
Rev. 1
2/9/2000
INSTRUCTION SHEET
GUTTER MAINTENANCE KIT
READ ALL SAFETY INSTRUCTIONS IN YOUR OWNER'S MANUAL
KIT DOES NOT INCLUDE BLOWER
1. Make sure blower has been turned off. Remove all tube
attachments from the blower. (See illustration 1.)
REMOVE
2. Make sure adapter is free to rotate on the elbow. Loosen
CLAMP and install over exposed end of elbow. (See illus-
tration 2.)
3. Attach above assembly (as shown in illustration 3) over
blower exhaust until elbow clamp groove matches blower
groove. Align assembly so adapter end points upward.
Tighten CLAMP SCREW.
4. Attach FULL ELBOW Threaded Joint onto straight tube.
Continue attaching Straight Tubes until the preferred length
is acquired. Make sure all Joints are screwed tightly into
position or the blower may vibrate and push tubes apart.
(See illustration 4.)
WEAR EYE PROTECTION!
ILLUSTRATION 1
ILLUSTRATION 2
ILLUSTRATION 3
UPPER ELBOW
SWIVEL ADAPTER
CLAMP
CLAMP SCREW
SWIVEL ADAPTER POINTS
UPWARD
For models:
HB180, HB180V, HB180VI, HB180VGK,
HB290, HB290V, HB390, HB390V, HB390VI
STRAIGHT TUBE
(As required)
LARGE
CLAMP
UPPER
ELBOW
SWIVEL
ADAPTER
FULL
ELBOW
ILLUSTRATION 4
READ ALL SAFETY INSTRUCTIONS IN YOUR OWNER'S MANUAL
STRAIGHT TUBE
(As required)
LARGE
CLAMP
UPPER
ELBOW
1. Make sure blower has been turned off. Remove all tube
attachments from the blower. (See illustration 1.)
3. Loosen CLAMP and place over exposed end of upper el-
bow. Install SWIVEL ADAPTER onto ADAPTER. (See illus-
tration 3.) Swivel adapter must be free to rotate on the
elbow.
2. Turn ADAPTER clockwise to screw into blower housing
until tight. (See illustration 2.)
4. Attach FULL ELBOW Threaded Joint onto straight tube.
Continue attaching Straight Tubes until the preferred length
is acquired. Make sure all Joints are screwed tightly into
position or the blower may vibrate and push tubes apart.
(See illustration 4.)
ILLUSTRATION 1
ILLUSTRATION 2
ILLUSTRATION 4
SWIVEL
ADAPTER
FULL
ELBOW
REMOVE
ADAPTER
KIT DOES NOT INCLUDE BLOWER
WEAR EYE PROTECTION!
ADAPTER
SWIVEL ADAPTER POINTS
UPWARD
ILLUSTRATION 3
UPPER
ELBOW
SWIVEL ADAPTER
CLAMP
ADAPTER
For models:
d25mhv, z25mhv, d30mha, d30mhv, i25mhv,
i30mhv, BVM160, HB25150, HB30160
/