Instruction manual
Bluetooth Micro System CD608
You’ll soon be enjoying your new Bluetooth Micro System.
It all begins here, with your instructions. Don’t worry, there’s
nothing too technical coming up. Just simple, step-by-step
guidance to get you up and running quickly. Sound good? Then
let’s get started.
Help and Guidance
We’re here to help you get the most from your Bluetooth Micro System. Should you
require any guidance, a simple solution can often be found online at:
www.argos-support.co.uk
If you still require further assistance, call one of our experts on 0345 600 3021.
Contents
1
Safety Information
General safety information 8
Moisture and water 8
Heat sources and flames 8
Ventilation 9
Positioning the Bluetooth Micro System 9
Power source 10
2
Getting to know your Bluetooth Micro System
Power connection 17
Initial set-up 17
Change the mode 17
Adjusting the volume 17
Mute 18
Equalizer or EQ setting 18
Set the clock 18
Sleep timer 18
Using headphones 19
Connect to a Bluetooth device 19
3
Using your Bluetooth Micro System
CD Mode 24
Play a CD 24
CD controls 24
Programmed play mode 25
Repeat and Random modes 26
Remove the CD 26
Contents
Caring for compact discs 27
FM Radio mode 27
Wire radio aerial 27
Tuning to an FM station 28
Storing an FM station preset 28
Tune to an FM station preset 29
Bluetooth mode 29
Listening to Music/Audio using Bluetooth 30
Delete all paired Bluetooth device records 31
Aux in mode 31
4
Other information
Technical specification 34
5
Product support
Troubleshooting 38
Help and assistance 39
Disposal 41
Your Bush Guarantee 42
This page is left intentionally blank
1
Safety information
Safety information
8
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
Safety information
Important - Please read these instructions fully before
installing or operating
General safety information
• Keep the product and all its parts out of reach of small children.
• This product is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance
by a person responsible for their safety.
• Do NOT place foreign objects into the CD compartment.
CAUTION
Never touch or look into the optical lens within the CD compartment.
This is a CLASS-1 laser product.
Use of controls or adjustments other than those specified herein, may result
in hazardous laser light beam exposure. Do NOT open the cover and do NOT
attempt to repair it yourself. Refer servicing to qualified personnel. This product
does not contain any user serviceable parts. Unauthorised handling of the
device may damage it and will void your warranty.
Moisture and water
• Do not leave it in low temperatures as moisture can form inside the product, which
may damage the circuit board.
• To reduce the risk of fire or electric shock, do not expose this product to rain or
moisture. Do not place objects filled with water, such as a vase, on the product.
Heat sources and flames
• Do not leave it in high temperatures as electronic devices and plastic parts may warp
in heat.
• No naked flame sources, such as lit candles, should be placed on the product.
Safety information
9
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Safety information
Important - Please read these instructions fully before
installing or operating
Ventilation
• Do not block or cover slots, holes or openings on the product by placing on soft
furnishings such as carpets, rugs or beds as these are provided for functionality and/or
ventilation to ensure safe operation of the product.
• The underneath and sides of this product may become warm after a long period of
use. This is normal.
Positioning the Bluetooth Micro System
It is important that you consider carefully in advance where your Micro System and
speakers will be situated and make sure that they are:
• on a flat and stable surface.
• within 1.4 metres of a power socket. Please ensure that the mains power lead and
speaker cables are not a trip hazard.
• at least 1 metre away from other electrical appliances to avoid interference.
• where it will be in range of the connected or ‘paired’ bluetooth device (e.g. iPod/
iPhone/iPad/Android/other phone/computer, which is about 10 metres or less (33 feet
or less) in line of sight.
• where there is enough height for the Micro System wire radio aerial.
• Never place your Micro System directly onto antique or polished surfaces.
CAUTION
To avoid possible hearing damage, do not listen to this Micro System at
high volume levels for long periods of time. Always keep the volume within
reasonable limits.
Safety information
10
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
Safety information
Important - Please read these instructions fully before
installing or operating
Power source
• Only use the power supply that came with the product. Using an unauthorised power
supply will invalidate your guarantee and may irrecoverably damage the product.
• Disconnect your Micro from the mains power supply during thunderstorms.
• Always check that you have completely switched off your Micro System, before you
change or disconnect the power supply.
• Where the mains power plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• If the Micro System will not be used for a long period of time, remove the CD and
make sure that the mains power is unplugged and the battery is removed from the
remote control.
• Only use recommended batteries or those of the same or equivalent type in the
remote control.
• Batteries are to be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.
• Never throw batteries in a fire or attempt to open the outer casing. Do not expose
them to excessive heat, such as sunshine.
• Batteries are harmful if swallowed, so keep away from young children.
CAUTION
Danger of explosion if batteries are incorrectly replaced. Replace only with the
same or equivalent type.
Safety information
11
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Safety information
Important - Please read these instructions fully before
installing or operating
WARNING
Do not ingest the battery, Chemical Burn Hazard.
The remote control supplied with this product contains a button cell battery. If
the button cell battery is swallowed, it can cause severe internal burns in just 2
hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
This page is left intentionally blank
Getting to know your Bluetooth
Micro System
2
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
Ready? Let’s begin...
Please read these instructions carefully. They contain important information which will
help you get the best from your product and ensure safe and correct installation and
operation.
If you require any further assistance, our technical experts are happy to help. For full
details, refer to the product support section at the end of these instructions.
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
15
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Fig 1.
1. Power on/off (standby)
2. CD Compartment
3. Backlit display
4. Rotary volume control (push to Select)
5. Play/Pause
6. Stop
7. Headphone socket
8. Mode
9. Prog.
10. Skip back/Tune -
11. Skip forward/Tune +
12. Line in
13. Left and Right speaker sockets
14. Mains power cable
15. Wire radio aerial
2 3 4
7
5
8 9 10
12
11
13
14 15
Fig 2.
1 6
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
1
3
2
4 13
Fig 3.
10
5
6
9
8
12
14
15
16
17
18
1. Power on/off (standby)
2. Skip back
3. Play/Pause
4. Clock
5. Scan
6. Program
7. Memory -
8. Pair
9. Mute
10. Equalizer
11. Mode
12. Skip forward
13. Stop
14. Sleep
15. Repeat
16. Volume +
17. Memory +
18. Volume -
7
11
Note: The remote signal may not be received if there is an obstacle between the
remote and the Micro. Direct sunlight or other bright light sources shining on the
remote sensor next to the Micro display, may affect the performance of the remote
control.
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
17
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Power connection
1. Connect the speakers to the Left and Right speaker sockets on the back of the Micro.
Please note that the speakers are shaped and so you will need to view them from the
front before you connect them to the speaker sockets.
2. Fully extend the wire radio aerial on the back of the Micro to receive the best possible
radio reception and sound quality.
3. Open the CD compartment (push and release the lid on the front right), and remove
the cardboard shipping protector. Close the CD lid.
4. Plug the mains power plug into the mains power wall socket and switch on. Your
Micro will now be in ‘Standby’ mode.
5. Pull out the safety strip on the remote control to activate the battery.
Initial set-up
Press and release the Power button on the front of your Micro System. The first time you
switch on your Micro it will start in CD mode, subsequently it will start in the mode you
were last using unless it has been unplugged from the mains power supply.
Change the mode
Press and release the Mode button to change between CD, FM Radio, Bluetooth and Aux
in modes. Please check the display, which will confirm the mode.
Adjusting the volume
Turn the rotary volume control clockwise to increase the volume and anti-clockwise to
decrease the volume.
Check the display, which will confirm the volume setting. The maximum volume is level
30.
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
Mute
Press and release the Mute button on the remote control to mute the sound. ‘00’ will
flash in the display.
Press and release the Mute button again to turn this feature off and unmute the sound.
Equalizer or EQ setting
You can change the sound of your Micro using the EQ setting, there are 4 options
available (Classic, Rock, Pop and Jazz).
Press and release the EQ button on the remote control to change the EQ setting.
Set the clock
In standby mode:
Press and hold the Clock button on the remote control, then use the and
buttons to scroll and the clock button to confirm, to select 12H/24H and set the clock
time. Once set, the clock time is displayed in standby mode.
Sleep timer
You can set your Micro to turn off automatically using the sleep timer. You can choose
from 10, 20, 30, 40, 50, 60, 70, 80, 90 minutes or OFF.
Continuously press and release the Sleep button on the remote control to cycle through
the available options, stop when the sleep time you would like is displayed.
Note: To cancel the sleep time, follow the steps to set the sleep time but stop when
‘OFF’ is displayed.
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
19
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using headphones
You can connect headphones with a 3.5mm plug (not included) to the socket on the front
of the Micro. When you have headphones connected the Micro speakers are switched off
and all sound is via the headphones.
Note: Always keep the volume within reasonable limits.
Connect to a Bluetooth device
Check that your Micro is in Bluetooth (BT) mode. If you are not already in BT mode,
repeatedly press and release the Mode button on the front of the Micro or on the remote
control until you are in BT mode (check the display). will flash in the display, whilst your
product searches for Bluetooth devices.
In Bluetooth (BT) Mode:
1. will flash in the display, whilst your product searches for Bluetooth devices.
2. On the device that you would like to connect to your Micro via Bluetooth (e.g. iPhone/
iPad/Android/other phone/Tablet/Computer), turn on Bluetooth connectivity and
ensure that it is ‘discoverable’.
Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.
3. Select to ‘Add new device’, if necessary.
Note: Some products will automatically search for a new device and so the ‘Add new
device’ option is not available.
4. When found, your Micro will be displayed as ‘BUSH FM MICRO’. Select the device
name to begin pairing.
5. When pairing is complete will stop flashing in the display, and will be constantly
displayed.
Getting to know your Bluetooth Micro System
You’ll be up and running in no time
Getting to know your Bluetooth Micro System
20
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troub les hoo tin g
6. Now that you have paired your device with the Micro, it will connect to it when it is
within range, which is about 10 metres or less (33 feet or less), line of sight.
7. Your device will remain paired with the Micro unless you decide to disconnect or
‘unpair’ it.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
