AEFGB
A. Refrigerator Compartment
1. Crisper drawer
2. Shelves / Shelf zone
3. Control panel/Thermostat unit with light (depending on the model)
4. Top shelf
5. Door trays
6. Bottle shelf
7. Removable bottle restrainer (if present)
8. Rating plate (at side of crisper drawer)
9. Light, located under the control panel or inside the product (depending on the model)
10. Fan with filter (if present), see specific instructions for filter
B. Low temperature compartment (if present)
Notes: The number of shelves and type of accessories may vary, depending on the model.
All shelves, door trays and racks are removable.
Important: Do not clean refrigerator accessories in a dishwasher.
PRODUCT SHEET
GB
A
B
A
3
2
8
1
10
9
2
8
1
3
4
5
7
6
AEFGB
5019 608 01113 Printed in Italy 04/12
1. Loosen the screw and remove the diffuser.
2. When replacing the lamp, bear in mind that
this appliance is fitted with a special lamp
(15W with bayonet connector); to replace, do
not unscrew it but pull towards the inside of
the refrigerator (as indicated by the arrow).
3. Refit the diffuser and secure it with the screw.
1. Unscrew the lamp as shown in the figure
2. Replace the lamp with one of the same power
or of the max. power in watt, specified near
the lamp holder.
REPLACING THE LAMP (depending on the model)
1. Thermostat knob
Thermostat to •/Off: refrigeration and refrigerator
compartment light are switched off.
Thermostat to 1-min: minimum refrigeration.
Thermostat to 7-max: maximum refrigeration.
It is advisable to set the thermostat to 3-
4/med.
The refrigerator can operate at ambient
temperatures between +10°C and +38°C.
Optimum performance is obtained at
temperatures between +16°C and +38°C.
Note: Ambient air temperature, the frequency of
door opening and the position of the appliance can
affect the internal temperatures of the refrigerator.
Take these factors into consideration when setting
the thermostat.
REFRIGERATOR COMPARTMENT
CONTROLS
(depending on the model)
/