Safeline GL2 User manual

Type
User manual

This manual is also suitable for

Safeline GL2 GSM-LINE-R

The Safeline GL2 GSM-LINE-R is a GSM alternative for all of our lift telephones. It is a compact and affordable device that can be easily installed in any lift. The GL2 GSM-LINE-R provides a reliable and cost-effective way to keep your lift connected to the outside world.

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including:

  • A backlit LCD display that shows the current time, date, and signal strength
  • A built-in speakerphone
  • A microphone jack for connecting an external microphone

Safeline GL2 GSM-LINE-R

The Safeline GL2 GSM-LINE-R is a GSM alternative for all of our lift telephones. It is a compact and affordable device that can be easily installed in any lift. The GL2 GSM-LINE-R provides a reliable and cost-effective way to keep your lift connected to the outside world.

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including:

  • A backlit LCD display that shows the current time, date, and signal strength
  • A built-in speakerphone
  • A microphone jack for connecting an external microphone
SafeLine GL2
Installation manual
ENGLISH V. 2.61
07.2012
A GSM alternative for all of our lift telephones.
safeline.eu
SafeLine GL2
TECHNICAL DATA
Communication:
GSM-module Quad band 900/1800, 850/1900 MHz.
Antenna connector type
SMA
Current consumption:
At 12V max. 0.25A momentarily when connecting a call, at rest: 0,05 A.
Size HxWxD:
120 x 105 x 30mm
Installation manual
Unit is beeing delivered with a 2,5m antenna cable, SMA contact (female)
3
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
ENGLISH V. 2.61
Table of contents
Components 4
Connecting the unit 4
Using the SIM-card 5
LED indication 6
RX Audio level 6
Troubleshooting 7
Interference/Poor sound quality 7
Installation
Service
Menu
4
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
SIM-card
1
2
3
4
5
6
>> 1,5m
>> 1,5m
>> 1,5m
ENGLISH V. 2.61
Installation
CONNECTING THE UNIT
Connect the unit to 12 or 24VDC. If the main power is 24VDC and battery back up 12VDC you will need
to connect both “+” lines separately.
External telephone can be connected on terminal or modular connector.
To avoid GSM interference: Place the GL2, the telephone(and stations)
and the GSM antenna more than 1,5 m apart.
COMPONENTS
SMA-antenna
connector
SIM-card holder
Reset button
Push to see GSM fi eld
intensity
LEDs
0V
+12 VDC
Line out
+20-30 VDC
Line out
Line out
Do not use
Do not use
Do not use
Do not use
Line out
RJ12
5
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
ENGLISH V. 2.61
Installation
USING THE SIM CARD
Before you can start using a new SIM card, the card has to be prepared and support 2G network.
Cards that only support 3G will not function.
The GL2 can only recognize the PIN code if the code is set to “0000”, “1234”, “1111” . In some cases the
code can also be deactivated. If the PIN code is set to “0000” or if it is deactivated the SIM card can be
moved from the GL2 to any of SafeLine GSM products. If the code is set to “1234” the SIM card can be
moved to another GL2/GL2/GL4/GL5 unit if the software version is 3.10 or higher. TIP Do not activate the
mailbox or if possible ask your provider to deactivate the mailbox.
If the Pin code is set to “1111” the SIM cards code will be randomly changed by the SafeLine GSM unit
and memorized. This way the SIM card can only work with the SafeLine GSM unit unless you use the PUK
code for setting up a new PIN code.
The randomly chosen PIN code is memorized by the unit. If you want to upload a new SIM card with PIN
code “1111” you will need to fi rst upload a SIM card with PIN code “0000” or “1234” this to clear the old
code in memory.
PIN code (set to “0000”, “1234” or deactivate).
1. Insert the SIM card in an ordinary cellular phone. In the “Security settings” menu, change the PIN
code to “0000”. If this is not possible , set the PIN code to “1234” or set the ”PIN code request”
option to “OFF”(might not always work).
2. Verify the PIN code by switching your phone off and on again.
3. Make a call from your phone to verify that the SIM card is active, before you move it to the GL2.
4. Also make a call to GL2 after insertion to check that it is possible to get a proper connection.
Protect the SIM card against unauthorized use.
1. Insert the SIM card in a cellular phone.
2. In the “Security settings” menu, change the PIN code to “1111”. When the SIM card is inserted in
the GL2, the code will be changed to a random number, thus making it impossible to use the card
in another cellular phone unless it is unblocked by means of the PUK code.
NOTE!
If you enter the wrong PIN code 3 times, the SIM card will be blocked (requires
PUK code to de-block). The GL2 cannot be started and the LED (4) will be red.
If PIN code “1234” is used, make sure the SafeLine GL2 software is 3.10 or
higher.
6
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
+25%
+0%
+50%
+75%
+100%
ENGLISH V. 2.61
Menu
LED 1 LED 2 LED 3 LED 4
Powering the unit
Flashing
Unit is operational
Flashing
SIM-card error*
Flashing Flashing Flashing Flashing
Outgoing call
Flashing 2 times/
second
Flashing
Outgoing call con-
nected
Flashing Lit
Incoming call
Flashing Flashing 3 times/
second
Incoming call con-
nected
Flashing Lit
Call disconnected
Flashing Flashing 2 times/
second
Signal strenght
<29% - Not enough
Lit
30-50% - Minimum
Lit Lit
51-75%
Lit Lit Lit
>75%
Lit Lit Lit Lit
*No SIM-card, Wrong PIN-code or SIM-card not activated.
LED INDICATION
INCREASE RX AUDIO LEVEL
Increase the GSM receiving audio level by use of the setup mode.
To enter setup mode, first disconnect the power. Then press the button and
hold while restarting power and then for a further 8 seconds without letting
go. The setup mode is now active. To setup the GSM receiving audio level
press the button to reach desired output level. The increase is in steps of
25% per push. When the desired level is reached, turn off the power and then
restart the unit. The new GSM receiving audio level is now stored.
Use this function with caution! The voice switching of the emergency phone
will be affected. +75% or +100% may only be used in uniqe installations
where it’s difficult to get the telephone to switch from the receiving part.
7
© 2012 SafeLine and all the SafeLine products and accessories are copyrighted by law.
ENGLISH V. 2.61
Service
TROUBLESHOOTING
The red LED does not start flashing when unit is connected to supply voltage.
• Check the supply voltage polarity.
• Make sure that the supply voltage is: 12 or 20-30VDC
All 4 LED’s starts flashing rapidly.
• Make sure that the SIM-card is correctly positioned.
• Check that the SIM-cards PIN-code is deactivated or that the PIN-code is set to ”0000” or ”1111”
(see the section SIM-card).
• Make sure that the SIM–card is activated and ”works” by testing the card in an cellular phone.
The call is interrupted directly after being connected.
• If the unit is powered from a battery make sure the battery is properly charged.
• If the unit is powered from a AC/DC or DC/DC transformer make sure that it can deliver 0.25A
continuous current.
Call can not be connected! Error message from telephone operator.
• To make a call, area code must always be used.
INTERFERENCE / POOR SOUND QUALITY.
• Bear in mind that the wiring between GL2 and the lift telephone/phone is basically a “standard”
PSTN-line and can therefore not be placed in the lifts travelling cable together with high voltage.
*** (Risk of interference)***
• Always place the antenna in an upward position and at least 1,5m from GL2.
• Place the antenna where the highest field intensity is obtained according to the table on the unit.
• When a call is connected try placing the antenna in different places to find where the best
receiving/sending position is.
safeline.eu/support
SafeLine Sweden
Antennvägen 10
13548 Tyresö
SWEDEN
Tel: +46(0)84477932
Fax: +46(0)84477931
SafeLine Europe
Blvd de la Woluwe 42,
1200 Brussels
BELGIUM
Tel: +32(0)2 762 98 10
Fax: +32(0)2 762 97 10
SafeLine-Deutschland
Westfalenstraße 22a
D-51688 Wipperfürth
DEUTSCHLAND
Tel: +49 (0) 2267 - 8 67 96 63
SafeLine Denmark
Erhvervsvej 19
2600 Glostrup
DENMARK
Tel: +45 44 91 32 72
SafeLine Elevator Parts UK
3 Evegate Park Barn
Smeeth
Ashford
Kent
TN25 6SX
United Kingdom
Tel: +44(0)1303 813414
Fax: +44 (0)1303 814529
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Safeline GL2 User manual

Type
User manual
This manual is also suitable for

Safeline GL2 GSM-LINE-R

The Safeline GL2 GSM-LINE-R is a GSM alternative for all of our lift telephones. It is a compact and affordable device that can be easily installed in any lift. The GL2 GSM-LINE-R provides a reliable and cost-effective way to keep your lift connected to the outside world.

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including:

  • A backlit LCD display that shows the current time, date, and signal strength
  • A built-in speakerphone
  • A microphone jack for connecting an external microphone

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI