Safeline GL2 User manual

Brand: Safeline

Model: GL2

Type: User manual

This manual is also suitable for

GL2 GSM-LINE-R

Safeline GL2 GSM-LINE-R

The Safeline GL2 GSM-LINE-R is a GSM alternative for all of our lift telephones. It is a compact and affordable device that can be easily installed in any lift. The GL2 GSM-LINE-R provides a reliable and cost-effective way to keep your lift connected to the outside world.

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including:

A backlit LCD display that shows the current time, date, and signal strength
A built-in speakerphone
A microphone jack for connecting an external microphone

Safeline GL2 GSM-LINE-R

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including:

A backlit LCD display that shows the current time, date, and signal strength
A built-in speakerphone
A microphone jack for connecting an external microphone

SafeLine GL2

Installation manual

ENGLISH V. 2.61

07.2012

A GSM alternative for all of our lift telephones.

safeline.eu

SafeLine GL2

TECHNICAL DATA

Communication:

GSM-module Quad band 900/1800, 850/1900 MHz.

Antenna connector type

SMA

Current consumption:

At 12V max. 0.25A momentarily when connecting a call, at rest: 0,05 A.

Size HxWxD:

120 x 105 x 30mm

Installation manual

Unit is beeing delivered with a 2,5m antenna cable, SMA contact (female)

ENGLISH V. 2.61

Table of contents

Components 4

Connecting the unit 4

Using the SIM-card 5

LED indication 6

RX Audio level 6

Troubleshooting 7

Interference/Poor sound quality 7

Installation

Service

SIM-card

>> 1,5m

ENGLISH V. 2.61

Installation

CONNECTING THE UNIT

Connect the unit to 12 or 24VDC. If the main power is 24VDC and battery back up 12VDC you will need

to connect both “+” lines separately.

External telephone can be connected on terminal or modular connector.

To avoid GSM interference: Place the GL2, the telephone(and stations)

and the GSM antenna more than 1,5 m apart.

COMPONENTS

SMA-antenna

connector

SIM-card holder

Reset button

Push to see GSM ﬁ eld

intensity

LEDs

+12 VDC

Line out

+20-30 VDC

Line out

Do not use

Line out

RJ12

ENGLISH V. 2.61

Installation

USING THE SIM CARD

Before you can start using a new SIM card, the card has to be prepared and support 2G network.

Cards that only support 3G will not function.

The GL2 can only recognize the PIN code if the code is set to “0000”, “1234”, “1111” . In some cases the

code can also be deactivated. If the PIN code is set to “0000” or if it is deactivated the SIM card can be

moved from the GL2 to any of SafeLine GSM products. If the code is set to “1234” the SIM card can be

moved to another GL2/GL2/GL4/GL5 unit if the software version is 3.10 or higher. TIP Do not activate the

mailbox or if possible ask your provider to deactivate the mailbox.

If the Pin code is set to “1111” the SIM cards code will be randomly changed by the SafeLine GSM unit

and memorized. This way the SIM card can only work with the SafeLine GSM unit unless you use the PUK

code for setting up a new PIN code.

The randomly chosen PIN code is memorized by the unit. If you want to upload a new SIM card with PIN

code “1111” you will need to ﬁ rst upload a SIM card with PIN code “0000” or “1234” this to clear the old

code in memory.

PIN code (set to “0000”, “1234” or deactivate).

1. Insert the SIM card in an ordinary cellular phone. In the “Security settings” menu, change the PIN

code to “0000”. If this is not possible , set the PIN code to “1234” or set the ”PIN code request”

option to “OFF”(might not always work).

2. Verify the PIN code by switching your phone off and on again.

3. Make a call from your phone to verify that the SIM card is active, before you move it to the GL2.

4. Also make a call to GL2 after insertion to check that it is possible to get a proper connection.

Protect the SIM card against unauthorized use.

1. Insert the SIM card in a cellular phone.

2. In the “Security settings” menu, change the PIN code to “1111”. When the SIM card is inserted in

the GL2, the code will be changed to a random number, thus making it impossible to use the card

in another cellular phone unless it is unblocked by means of the PUK code.

NOTE!

If you enter the wrong PIN code 3 times, the SIM card will be blocked (requires

PUK code to de-block). The GL2 cannot be started and the LED (4) will be red.

If PIN code “1234” is used, make sure the SafeLine GL2 software is 3.10 or

higher.

+25%

+0%

+50%

+75%

+100%

ENGLISH V. 2.61

LED 1 LED 2 LED 3 LED 4

Powering the unit

Flashing

Unit is operational

Flashing

SIM-card error*

Flashing Flashing Flashing Flashing

Outgoing call

Flashing 2 times/

second

Flashing

Outgoing call con-

nected

Flashing Lit

Incoming call

Flashing Flashing 3 times/

second

Incoming call con-

nected

Flashing Lit

Call disconnected

Flashing Flashing 2 times/

second

Signal strenght

<29% - Not enough

Lit

30-50% - Minimum

Lit Lit

51-75%

Lit Lit Lit

>75%

Lit Lit Lit Lit

*No SIM-card, Wrong PIN-code or SIM-card not activated.

LED INDICATION

INCREASE RX AUDIO LEVEL

Increase the GSM receiving audio level by use of the setup mode.

To enter setup mode, first disconnect the power. Then press the button and

hold while restarting power and then for a further 8 seconds without letting

go. The setup mode is now active. To setup the GSM receiving audio level

press the button to reach desired output level. The increase is in steps of

25% per push. When the desired level is reached, turn off the power and then

restart the unit. The new GSM receiving audio level is now stored.

Use this function with caution! The voice switching of the emergency phone

will be affected. +75% or +100% may only be used in uniqe installations

where it’s difficult to get the telephone to switch from the receiving part.

ENGLISH V. 2.61

Service

TROUBLESHOOTING

The red LED does not start ﬂashing when unit is connected to supply voltage.

• Check the supply voltage polarity.

• Make sure that the supply voltage is: 12 or 20-30VDC

All 4 LED’s starts ﬂashing rapidly.

• Make sure that the SIM-card is correctly positioned.

• Check that the SIM-cards PIN-code is deactivated or that the PIN-code is set to ”0000” or ”1111”

(see the section SIM-card).

• Make sure that the SIM–card is activated and ”works” by testing the card in an cellular phone.

The call is interrupted directly after being connected.

• If the unit is powered from a battery make sure the battery is properly charged.

• If the unit is powered from a AC/DC or DC/DC transformer make sure that it can deliver 0.25A

continuous current.

Call can not be connected! Error message from telephone operator.

• To make a call, area code must always be used.

INTERFERENCE / POOR SOUND QUALITY.

• Bear in mind that the wiring between GL2 and the lift telephone/phone is basically a “standard”

PSTN-line and can therefore not be placed in the lifts travelling cable together with high voltage.

*** (Risk of interference)***

• Always place the antenna in an upward position and at least 1,5m from GL2.

• Place the antenna where the highest ﬁeld intensity is obtained according to the table on the unit.

• When a call is connected try placing the antenna in different places to ﬁnd where the best

receiving/sending position is.

safeline.eu/support

SafeLine Sweden

Antennvägen 10

13548 Tyresö

SWEDEN

Tel: +46(0)84477932

Fax: +46(0)84477931

E-mail: [email protected]

SafeLine Europe

Blvd de la Woluwe 42,

1200 Brussels

BELGIUM

Tel: +32(0)2 762 98 10

Fax: +32(0)2 762 97 10

E-mail: [email protected]

SafeLine-Deutschland

Westfalenstraße 22a

D-51688 Wipperfürth

DEUTSCHLAND

Tel: +49 (0) 2267 - 8 67 96 63

E-mail: [email protected]

SafeLine Denmark

Erhvervsvej 19

2600 Glostrup

DENMARK

Tel: +45 44 91 32 72

E-mail: [email protected]

SafeLine Elevator Parts UK

3 Evegate Park Barn

Smeeth

Ashford

Kent

TN25 6SX

United Kingdom

Tel: +44(0)1303 813414

Fax: +44 (0)1303 814529

E-mail: [email protected]

Safeline GL2 User manual

Brand: Safeline

Model: GL2

Type: User manual

This manual is also suitable for

GL2 GSM-LINE-R

Safeline GL2 GSM-LINE-R

The GL2 GSM-LINE-R supports all major GSM networks and comes with a built-in antenna. It also has a number of features that make it easy to use, including: