Ignis ADL 934 ME Program Chart

Category
Dishwashers
Type
Program Chart

Ignis ADL 934 ME is a dishwasher with three programs: Pre-wash, Intensive 65°C, and Daily 65°C. It features adjustable racks, a cutlery basket, and a salt and rinse aid level indicator. The device is easy to use, with a simple control panel and indicator lights. It is energy-efficient, consuming 1.64 kWh in the Daily 65°C program. The dishwasher is also quiet, operating at a noise level of 52 dB.

Ignis ADL 934 ME is a dishwasher with three programs: Pre-wash, Intensive 65°C, and Daily 65°C. It features adjustable racks, a cutlery basket, and a salt and rinse aid level indicator. The device is easy to use, with a simple control panel and indicator lights. It is energy-efficient, consuming 1.64 kWh in the Daily 65°C program. The dishwasher is also quiet, operating at a noise level of 52 dB.

Further indications are given in the pages to follow and in the user instructions
Programme selector
On/Off button
Programme Symbol
and Temperature
Programme selection and
recommended load type
Place the detergent
in the following compartment
Consumption
1)
Normal load
small (A) large (B)
Water
(Litre)
Energy
(kWh)
Time
(Min.)
1
Pre-wash
Crockery to be washed later.
- - 4.5 0.10 10
2
Intensive 65° C
Normally or heavily soiled crockery with dried-on food.
X X 20.0 1.70 110
3
Daily 65° C
2)
Normally soiled crockery.
- X 16.0 1.64 100
Quick Reference Guide
GB
5019 100 93310
(We reserve the right to make technical modifications)
1) Values may vary in relation to, for example, different loads, water
temperature - above or below 15° C - or water hardness, and power supply voltage, etc.
2) Reference programme for Test Institute and energy-label.
ADL 934
1. After loading the crockery, close the
dishwasher door properly and turn
on the water supply.
2. Select the desired programme by
turning the selector’s knob
clockwise: position 1: “Pre-wash”;
position 2: “Intensive”; position 3:
“Daily”. The dishwasher starts
automatically as soon as the On/Off
button has been pressed.
3. Press the On/Off button to switch
the dishwasher on. The indicator
lamp switches on.
To change the selected
programme, press the On/Off
button to turn the dishwasher off
and then turn the selector knob
to the desired programme. Press
the On/off button to start the
newly selected programme.
Note:
if you switch off the dishwasher
during a wash cycle, when switched on
again, the dishwasher resumes the
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
4. The wash programme is over when
the selector's knob is back in the
Stop position.
5. Switch off the dishwasher now by
pressing the On/Off button. All the
indicator lamps switch off.
6. Open the door (warning: beware of
hot steam). Unload the lower rack
before the upper one.
Close the water tap.
Upper rack
Crockery holders:
Down: cups and long-stemmed
glasses.
Up: plates.
Lower rack
Cutlery basket (A):
The cutlery basket can be either
inserted or removed to increase
available space, as required.
If present, the central
compartment is recommended
for storing teaspoons.
Plate holders (B) (if available):
How to use the dishwasher
Please read the user instructions carefully.
Upper and lower rack
Tips and advice
Arrange crockery so that items do not
touch each other. Arrange large
crockery in the lower rack and smaller
crockery in the upper rack.
Load cups at an angle to facilitate
water circulation.
Generally speaking, place cutlery in the
basket with the handles positioned
downwards, but ensure that any sharp
knives and forks that might cause
injury are placed in the basket with the
handles positioned upwards.
Make sure the water jet can reach all
loaded items and that the spray arms
turn freely.
Important
Fill the detergent dispenser and check
the salt and rinse aid level.
Do not use the appliance for items not
suitable for washing in a dishwasher,
for example: items made of wood,
aluminium, plastic, tin, (non enamelled)
decorated crockery, silver cutlery.
Do not put liquid fat in the dishwasher
(e.g. oil used for frying) or candle wax.
If regeneration salt is to be added,
immediately
start a wash programme
in order to eliminate any residual salt
(rinsing alone is not sufficient).
Sometimes, even though the
regeneration salt container has been
filled, the corresponding indicator light
(if fitted) will light up during the first
wash cycle after filling with salt.
Before starting a wash programme,
make sure that the spray arms can turn
freely and are not blocked by crockery
or cutlery.
Switch off the dishwasher only after the
selector's knob is back in the start
position. If the dishwasher is turned off
during the washing programme, when
switched on again, the dishwasher
resumes the wash cycle from where it
was interrupted
If a fault occurs, before contacting our
After-Sales Service, make the following
checks to try and remedy the problem:
The dishwasher is not working:
Is the plug properly inserted in the wall
socket?
Is there a power failure?
Is the dishwasher switched on?
Is the water supply tap on?
Is the flow of water obstructed by
impurities? If so, close the water supply
tap, detach the water hose and clean the
filter. Then re-connect the water hose to
the tap and open the water tap once
again.
Are the filters clogged? (see Care and
Maintenance chapter in user
instructions).
Is the door closed properly?
Crockery still dirty after washing:
Was the crockery loaded properly?
Crockery must be loaded facing
downwards; make sure, especially for
large crockery, that water can run away
immediately without being trapped inside
the crockery.
The water jets must spray the entire
surface of all items.
Make sure that crockery and cutlery are
arranged properly.
Have you selected the correct programme?
Did you use too much or too little
detergent? (The use of poor quality
detergents result in less effective washing).
Are the filters clogged or incorrectly
assembled? (See Care and Maintenance
chapter in the user instructions).
Are the spray arms blocked or the nozzles
clogged? (See Care and Maintenance
chapter in the user instructions).
Is the salt container cap (water softening
system) screwed down?
Marked crockery:
Is the salt dispenser properly adjusted?
(See Filling the salt container in the user
instructions).
Is the salt container empty?
(See Filling the salt container in
the user instructions).
Was too little detergent used?
(See Filling the detergent dispenser
in the user instructions).
Marked glasses and cutlery:
Was too much rinse aid used?
(See Filling the rinse aid dispenser
in the user instructions).
If, after carrying out the above checks
the malfunction persists or appears
again, turn the appliance off and turn
off the water supply tap, then call
our After-Sales Service (see guarantee).
Please specify:
The nature of the fault.
The appliance type and model.
The service code (the number indicated
after the word Service on the adhesive
rating plate) inside the door on
the right-hand side.
Your full address and
telephone number.
AFTER-SALES
SERVICE
Troubleshooting Guide
Please read the user instructions carefully.
LOWER RACK
Load
Load capacity:
(according to International Norms
EN 50242-DIN 44990-IEC 436)
Detergent:
(according to Norm EN 50242)
Test Programme:
Upper and Lower Rack (Normal Load)
12 settings (dishes and serving dishes)
Type B: 25 g (Daily 65° C programme)
Daily 65° C
UPPER RACK Test Institute Information
Dishwasher Loading Instructions
Depending on the model, rack features may vary (see Upper and lower rack description).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Ignis ADL 934 ME Program Chart

Category
Dishwashers
Type
Program Chart

Ignis ADL 934 ME is a dishwasher with three programs: Pre-wash, Intensive 65°C, and Daily 65°C. It features adjustable racks, a cutlery basket, and a salt and rinse aid level indicator. The device is easy to use, with a simple control panel and indicator lights. It is energy-efficient, consuming 1.64 kWh in the Daily 65°C program. The dishwasher is also quiet, operating at a noise level of 52 dB.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI