OPERATINGINSTRUCTIONS
- 3 -
Pleaseusebothhands to
carefullyemptythewatertank.
●DEFROST
●Operation
1) Placethe product in an upright position onaflat,steady,
stable, heat-resistant surface. Makesure there is nothing
flammable or heat sensitivewithin100 cm .
Operating the product in any other position could be
hazardous.
2) Insert theplug into a suitable wall socket. The dehumidifier
is suitable for operation on an electricity supplyof the
same voltage as thatshown on its rating label.
3) Makesurethewatertankiscorrectlylocated.(After
switching on themachine for thefirst time, if the "Bucket
Full" lamp illuminates, just pull out the watertank, check
the "float" lever is able to movefreely, then return the water
tanktothecorrectposition.)
●WhenBucketFullLamp Is On
When the water tank is full the machine will stop andthe"Bucket Full"light
willilluminate.The water tank should be carefullyremoved fromthe
machine by sliding it outwards from the front of the machine and it should be
emptied. When the emptytank is replaced properly into the machine, the
machine willstart up andrunnormally.
When the machine is operated at lowtemperatures (less than 12°C) the surface of
the evaporator may accumulatealayer of frost which would reducethe efficiency
of themachine.When this happensthemachine will go intoperiodic defrostmode.
The defrost symbol onthe LCD display will comeon.Themachine will operate
in temperatures down to 5 . The time taken to defrostmayvary. If the machine
freezes up, it should be turned off at the power supplyandre-started. If the room
temperatureremains below 5 themachine should be switched off.
°C.
°C