SKODA RCD510 Installation guide

Category
Car video systems
Type
Installation guide
SKODA RCD510 Multimedia Video GPS Installation--Delphi
Video Unit features:
1. It is for SKODA RCD510 Radio head unit Delphi monitor.
2. to up date the original screen play after market DVD, TV, rear camera, GPS, other video unit
3. can use original touch screen to operate GPS function
4. Built-in GPS, very easy and excellent operation.can be suitable for GARMIN, IGO8, etc Window CE system.
5. Built-in FM sound transmittion, when you set the original Radio into FM87.9, then you can hear the sound
from original speaker when you connect after market DVD, TV, etc.
6. DIP5: when car is with original rear camera, set it in UP position, when car is without original rear camera, set
it Down position to after-market rear camera available.
7. It you do not need to our unit built-in GPS, then you can also use external NAVI BOX to connect with our
video interface.
8. Use original button switch the function.
9. 100% plug and play.
GPS Technical Data:
1. Main Control Processor: SiRF Atlas IV, and main frequency: 500MHZ
2. main storage: 64M ,128M (optional:DDR I)
3. Flash storage: 64M,128M,1G,2G (optional:Nand flash )
4. video output format: RGBCVBSYC,digital: RGB565
5. Synch signal: composite sync signal, and synchronizing signal separation
6. video output system: NTSCPAL
7. video output resolution: 320X240,400X234,480X234,800×480
8. GPS antenna power: 3-5V
9. Operation system: WINCE.NET 6.0 Core Version
10. Input voltage: 5V-24V
11. Touching panel connection: 4PINS resistance touching function
12. Memory Card: SD/MMC/SDHCSDHC4GB~32GB
1. After detach the Radio, remove these screws 2. detach original Touch cable connection
To instal touch function.
3. Original touch cable and connector connection 4. Our Golden Cable instruction
5. our Golden cable 1 marked to connect with original 6. Our golden cable marked 2 to connect original touch
golden cable Marked 1 as picture 3 connector marked 2, as picture 3
7. Detach original FPC cable connection, then 8. our Golden cable to connect with original
Our golden cable connector makred 3 as the above picture 4 to LCD and Radio PCB picture.
Connect with original LCD panel cable marked 9 as this pisture.
Our Golden cable marked 4 as the above picture 4 to connect
With original Radio PCB mark 8 like as this picture.
9. Remove this original switch cable as the picture show 10. Use our switch cable to replace the original switch
( it is the In the right side of this cable, not the left side, cable: as this piscture show: 5 to connect with
please do care) Original LCD PCB, 6 is to connect with Our
Golden cable 2PIN white connector. 7 is to
Connect with original Radio PCB.
11. The Golden cable finished connection. 12. Golden cable to Video GPS unit
13 You can press the original button mark circule to switch 14. Also you can use this toggle switcher to
AV1AV2NAVIOriginalAV1 Switch: AV1AV2NAVIOriginalAV1
→→
DIP SETTING:
DIP Funtion Down UP
1 RGB ON OFF
2 AV1 ON OFF
3 AV2 ON OFF
4 After market camera ON OFF
Aftrer market camera ON OFF 5 Original camera OFF ON
6 EMPTY
7 EMPTY
Available buit-IN GPS OFF On 8 Available for eternal NAVI BOX on off
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

SKODA RCD510 Installation guide

Category
Car video systems
Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI