KUZCO CH10356 LED Chandelier Installation guide

Hello! I have analyzed the provided installation sheet for the Kuzco LED Chandelier model CH10356. This document includes step-by-step instructions for mounting, wiring, and connecting the fixture. It also highlights key safety precautions and technical specifications such as the ELV dimmer requirement and the need to reinforce the junction box due to the fixture's weight. I'm here to assist you with any questions you may have about its installation.
What type of dimmer is required?

Is it safe to touch LED modules?

Does the junction box need reinforcement?

You have now completed the installation of your fixture,

enjoy.

You are now ready to mount the canopy (2a) to the

mounting plate (1c). First connect all wires correctly G

ground to ground, N neutral wire (white to white), L live

wire (black to black) with provided marettes (1b) from the

hardware package. Align the holes in the canopy (2a) to

the threaded holes in the mounting plate (1c). Push the

canopy up towards the ceiling. Use the screws (2b) to

secure the canopy onto th mounting plate. Connect the

metal tube (2d) to the canopy by threading in clockwise.

Remove the fixture from its original packaging. Remove the

mounting plate (1c) from within the canopy (2a) by remov-

ing the metal tube (2d) and loosen the screws (2b). Secure

the mounting plate (1c) to the junction box (1a) with the

screws (1d) provided in the hardware package.

INSTALLATION SHEET

CH10356

LED Chandelier

START FROM HERE

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

CAUTION: HEAVY FIXTURE, THE JUNCTION BOX NEEDS TO BE REINFORCED

BEFORE INSTALLATION.

2. Before you mount the canopy (2a) to the mounting plate

(1c) connect the rods (2e) together by threading clockwise

starting from the pendant (3a) up to the top. Attach the rods

(2e) with the fixture to the swivel connector (2c) by thread-

ing in clockwise.

19054 28th Avenue Surrey, BC Canada V3Z 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20181207

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support: 1-855-855-8926

2d.

3a.

1a.

1b.

1c.

1d.

2a.

2c.

2e.

2b.