2. Soyal
  3. 101-PBI

Soyal 101-PBI Owner's manual

  • Hello! I'm your AI assistant, and I've reviewed the SOYAL AR-101-PBI user manual. This document provides detailed instructions on how to install, wire, and adjust the touchless infrared sensor button. It covers various mounting options and wiring configurations for different types of door locking systems along with optional LED control for door status indication. I'm ready to answer any questions you may have about this device.
  • What happens if the power is not wired to the AR-101-PBI?
    How can I adjust the detection range of the infrared sensor?
    What is the purpose of the LED external control?
V221026
SOYAL
ACCESS & INDUSTRIAL CONTROL
3
LED G
LED R
+5V
a. b. c. d. e. f.
5
d.
EXIT
Ø
2
4
41
ØØ
Ø
1
a.
c.
e.
EXIT
f.
EXIT
Ø
b.
CN2 PIN Color Description
LED R
LED G
1 Red Red LED negative
2 Green Green LED negative
Controller has built-in resistor and connected to
+5VDC, external power supply current must be
exceeding 20mA
Adjusting infrared detection range
Turn RIGHT: Longer / Turn LEFT: ShorterTurn
Function Cable Color Description
Relay COM 1 Green DC24V / 1A
N.O. 2 Blue DC24V / 1A
N.C. 3 Purple DC24V / 1A
Power 4 Black DC 0V
5 Red DC 9-24V
Connector:
Remove the black ABA Screw Nut from Button
1
Adjust detection range of infrared sensor
3
2
Use a screwdriver to screw the mounting plate on
the wall.
4
Paste the label sticker to nish installation.
5
Installation:
AR-101-PBI
Touch-less Infrared Sensor Button
※ The shape of mounting plate
is optional on demands.
※ Two panel styles are
optional
Install Button to the selected mounting plate.
Installation
Connector Table Wiring Diagram
LED external control (Optional)
*When POWER is not wired, AR-101-PBI become
powerless, it can still open door by hard press it.
＊The Wiring Diagram of LED
R/G Door Status Indication
Type A
The magnetic circuit will be turned on
when getting closed to the switch.
(closed circuit).
The magnetic circuit will be turned off
after removed the magnet. (open circuit)
Double contact–NO. / COM
Trigger LED R when door open
Trigger LED G when door closed
Triple contact -
NO. / NC. / COM
Type C
N.O.
COM
N.C.
V-
V+
LED G
LED R
AR-MS-101-A
AR-MS-101-C
N.O.
N.C.
COM
V+
GND
9-24VDC
Door Sensor
POWER
Request
To Exit
Model:
a.DMET-101PJ01
(Stainless steel plate)
b.DMET-101PJ05
(Stainless steel plate)
c.DMET-101PJ03
(Stainless steel plate)
d.AR-PB-6A
( plastic panel)
e.AR-PB-7A
( plastic panel)
f.AR-PB-8A
( plastic panel)
N.C.
COM
PB
V+
GND
V+
GND
V+
GND
GND
N.O.
COM
N.C.
V+
V-
N.O.
COM
N.C.
V-
V+
LED G
LED R
PUSH
BUTTON
9-24VDC
POWER
9-24VDC
POWER
Controller Request
To Exit
Electric Bolt
or
Magnetic Lock
Electric Strike
/