Infineon CY8CPROTO-062S2-43439 Quick start guide

  • I've reviewed the Quick Start Guide for the Infineon PSoC 62S2 Wi-Fi Bluetooth CY8CPROTO-062S2-43439 prototyping kit. This document provides instructions on how to set up, use its features like the CAPSESNSE buttons and slider, and how to execute the pre-programmed code. I'm ready to assist you with any questions you may have about this kit.
  • What should I do before starting?
    How do I execute the pre-programmed code example?
    How to control the LED4?
PSoCTM 62S2 Wi-Fi Bluetooth® prototyping kit
CY8CPROTO-062S2-43439
Document Number: 002-36468 REV. **
Date: 03 / 2023
Quick start guide
Low-cost hardware platform that enables design and debug of PSoC™ 6 MCUs
1. Before you start :
• Ensure that jumper J3 is at position 2–3 to select 3.3 V
• Connect the KitProg3 USB connector (J8) to your PC, using the provided USB cable
• Observe that the Power LEDs and KitProg3 status LED turn ON
• Wait for the KitProg3 USB driver installation to complete
2. Press the RESET switch (SW1) on the kit to execute the pre-programmed code example.
3. Touch CAPSENSETM button 1 (BTN1) to turn the LED4 OFF, touch CAPSENSETM button 0
(BTN0) to turn the LED4 ON, and swipe across the slider to change the LED brightness
when the LED4 is in the ON state.
4. Visit the kit webpage to access the kit guide, and find information on soware support,
code examples.
Published by Infineon Technologies AG
81726 Munich, Germany
Kit webpage: www.infineon.com/CY8CPROTO-062S2-43439
© 2023 Infineon Technologies AG.
All Rights Reserved.
RESET switch (SW1)
CAPSENSE™
button 0 (BTN0)
Slider
User LED (LED4)
Power LED
(LED1) Status LED
(LED2) Module power
LED(LED3)
CAPSENSE™
button 1 (BTN1)
KitProg3 USB connector (J8)
Power selection
jumper (J3)
PSoC™ Rocks!
Contents under the label
PSoC™ 62S2 Wi-Fi Bluetooth® prototyping kit
CY8CPROTO-062S2-43439
/