Page is loading ...
80X100mm
Touch Control Instructions
If the headset is stuck or other functions cannot be used normally,
you can click " " red and blue lights on twice for 3 seconds, the
red and blue lights will flash alternately, and the headset will be
restored to factory Settings.
1 x USB Type-C Cable
Model: OpenBuds Kids
1 X ACREO OpenBuds Kids
1 × User Manual
Package Contents
LED Indicator
Function Instructions How to Charge the Headphone
1. When using the OpenBuds Kids for the first time, please power on
the headphones via touch and hold for 5 seconds, the headphone will
automatically come into the pairing mode.
2. If the product is in pairing mode, it will display"ACREO OpenBuds
Kids" as the Bluetooth name on the smartphone, please select and
connect.
The Next Generation Open Ear
Headphones for Kids
The Next Generation Open Ear
Headphones for Kids
Model: OpenBuds Kids Touch area
Type-C Charging Port
HeadBand with Memory Steel Wire
Type-c charging port
Charging instructions:
When charging indicator light,
red light is steady on.
When fully charged, turn on
the blue light.
Quick Start Guide
Restore factory settings
Press and hold " " for 5 seconds
Press and hold " " for 5 seconds
Press " " 3 times
Press " " 2 times
Press " " 1 times
Press " " 4 times
Press " " 5 times
Short press " " 1 time when calling
Short press " " for 2 times continuously
Press " " for 2 seconds during incoming call
Power on
Power Off
Volume +
Volume -
Previous Track
Next Track
Play/Pause
Answer/Hang up
Restore factory settings
Reject to Answer the Call
LED indicator Instructions
Pairing Mode--Red and blue light
flash alternately
Connected Mode--Blue light flashes
1 time at 5 seconds interval
Make sure the headphone is fully charged before first use.
1. The headphone has a built-in li-on battery, which must be charged
at least once every 2 months if it is not used for a long time.
2. Use the USB type C cable to charge the headphone, you can use
any USB power input 5V 500mA adapter included, and the computer
USB port is fine.
3. When charging, the headphone will automatically shut down, and
the indicator light shows below
ACREO OpenBuds Kids
Touch and hold
for 5 seconds
3. After being connected successfully, it will be ready to play music,
make calls, and so on.
Note When the headphone is not in the connection status for more
than 5 minutes, the headphone will automatically shut down.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
FCC Statement
/