&Tradition Capture SC77 User manual

Brand
&Tradition
Model
Capture SC77
Category
Cleaning media
Type
User manual

&Tradition Capture SC77 is a coat stand designed in 2022 by Space Copenhagen. It is made of powder coated metal and lacquered wood, and is intended for indoor use. The coat stand has four legs, four hooks, and three spacers with four holes and two spacers with eight holes. It is easy to assemble, and comes with an Allen key for tightening the screws. The coat stand is stable, even on uneven floors, and can be adjusted using the adjustable gliders.

&Tradition Capture SC77 is a coat stand designed in 2022 by Space Copenhagen. It is made of powder coated metal and lacquered wood, and is intended for indoor use. The coat stand has four legs, four hooks, and three spacers with four holes and two spacers with eight holes. It is easy to assemble, and comes with an Allen key for tightening the screws. The coat stand is stable, even on uneven floors, and can be adjusted using the adjustable gliders.

Congratulations with you new Capture coat stand,
designed in 2022 by Space Copenhagen. We hope
you will enjoy using this product and follow these
instructions to ensure correct assembly. If you have
any questions or comments, please do not hesitate to
contact us by mail on:
[email protected]
Capture SC77
Space Copenhagen
2022
User instructions
Please read these instructions carefully and retain them
for future reference to ensure that the product is used
correctly. For your own safety, please study each step of
this instruction manual first. &Tradition is not responsible
for any faults or damages caused by not following these
instructions correctly. Do not modify this product in
any way.
Contents
A - Legs x 4
B - Hooks x 4
C - Spacer with four holes x 3
D - Spacer with eight holes x 2
E - Screws x 28
F - Allen key
Safety precautions
- Dispose of plastic bag from packaging and do not allow
children to play with it.
- The coat stand is only intended for indoor use.
Cleaning instructions
Powder coated metal
It is recommended only to use a soft dry cloth to clean
powder coated surfaces but in case more severe cleaning
is necessary, a soft cloth wrung in lukewarm water can be
carefully applied. Always dry immediately after cleaning
with a soft dry cloth. Avoid using abrasive cleaning agents
or aggressive cleaning detergents on powder coated
surfaces as this may permanently damage the surface.
Lacquered wood
For daily care it is recommended to dust the furniture
with a soft cloth. Lacquered wood can be cleaned with a
soft cloth wrung in a mild solution of lukewarm water and
a universal cleaning detergent. Always follow the wood
grains and always dry with a soft dry cloth immediately
after cleaning. Avoid use of abrasive cleaning agents and
aggressive cleaning detergents as this will damage the
surface of the lacquered wood. Avoid placing wooden
furniture in direct sunlight, excessive heat or humidity.
Step 1
Attach the spacers (C+D) to one of the legs (A) by
following the instructions below. This is done by fastening
the screws (E) with the Allen key (F).
Make sure not to tighten the screws completely until all
four legs have been attached.
Attach two spacers with eight holes (D) in the middle
section of the leg. One spacer with four holes (C) is
placed in the top part of the leg, and two spacers with four
holes should be attached to the bottom part as shown.
Make sure the disc (C) with the logo on is placed at the
bottom and has the logo facing downwards.
A
CB D
E
Capture SC77
Space Copenhagen
2022
F
Step 2
Place another leg (A) and fasten the screws (E) with
the Allen key (F).
Repeat for the remaining legs.
Step 3
Attach the hooks (B) on the spacers in the middle
by fastening the screws (E) with the Allen key (F).
NB: If the coat stand is unstable due to ueven floor,
please adjust it using the adjustable gliders.
andtradition.com
  • Page 1 1
  • Page 2 2
  • Page 3 3

&Tradition Capture SC77 User manual

Brand
&Tradition
Model
Capture SC77
Category
Cleaning media
Type
User manual

&Tradition Capture SC77 is a coat stand designed in 2022 by Space Copenhagen. It is made of powder coated metal and lacquered wood, and is intended for indoor use. The coat stand has four legs, four hooks, and three spacers with four holes and two spacers with eight holes. It is easy to assemble, and comes with an Allen key for tightening the screws. The coat stand is stable, even on uneven floors, and can be adjusted using the adjustable gliders.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents