2. SINOTRACK
  3. JET01
JET01

SINOTRACK JET01 User manual

  • Hello, I've reviewed the user manual for the GPS Locator JET01. This document covers installation, charging, power, positioning modes, and voice recording features. I'm ready to answer your questions about this device.
  • How do I turn on the device?
    How do I install the SIM card?
    How long does it take to fully charge the device?
    What is the initial password for the app?
Portable GPS Locator
JET01
1. Appearance schematic diagram
USB charging port
SIM card
interface
switch
Lanyard hole
microphone
2. Install the SIM card
a. selects the SIM card size
Please buy a standard Micro SIM card
(recommended not to cut the card)
GeninstallstheSIMcard
b.Install SIM card
Open the soft glue plug (open in the USB icon
position), and insert the SIM card in the correct
direction, as shown in the figure below
3. Charge the equipment
When the charger is connected, the red light of
the device will often illuminate, which means
charging, the green light means full
* If there is no electricity at all, be full for about 2 hours
* Charging is normal to have a micro-heating phenomenon
* The switch machine can be charged
* 5V charge
charging indicator
4. powered on and powered off
* starting up
Press the switch button for 3 seconds, see the blue light on
(representing power on) to release
* search the Internet
After the boot will need to search the network, when the
equipment blue lights will flash
(No installed card / invalid card keeps flashing)
* Run feedback:
During normal operation, the equipment will illuminate the key
blue lights, which is in normal operation
Press the switch if the blue light is not on means that the
equipment is out of power, charge
* shut down
Press the switch key for 5 seconds, and the equipment blue
light flashes (representative Shutdown down) to release
5.mobile phone scan download APP
a.Use the mobile phone scan to download the APP software
for installation
b.Enter the numeric code on the product,Initial password
123456
6.Description of the letter function
mode
Smart positioning (for emergency continuous updating of
location, power consumption): The device gets the latest location
every 30 seconds
Timed positioning (recommended to use, this mode is more
power saving): the equipment can choose 10 minutes / 30 minutes
/ 1 hour to obtain the latest position
Depth dormancy (very power saving): The device is always on
standby and refreshed through APP to get the latest position
Note: The factory default is the timing positioning mode (10
minutes)
7.Recording / listening / automatic
recording
sound recording
Open the APP-one recording-one select duration-one
determine one-Wait about 10 minutes to receive the voice
monitor
Open the APP-a listen one-enter the listen number and wait
about 10 seconds to receive a call
(If the card is a voice card.)
Automatic recording
With this function on, the device will regularly record and
upload it (more power consumption and flow consumption)
/