CHW4070 / CHW4070s
Hot & Cold Water Dispenser
INSTRUCTION MANUAL
Cauon: Read and follow all safety and operang instrucon before rst use of this product.
Campomac S.R.L. Via Congliachi 5/B . 35031, Abano Terme (Padova), ITALIA
WWW.CAMPOMATIC.COM
Made in China
2
CHW4070 / CHW4070S
Table of Content
English ________________________________________ 3
French _________________________________________ 8
___________________________________________ 18
ENG
3
CHW4070 / CHW4070S
ENG
1- PARTS NAME
l. Water guard
2. Cooling lamp (Green)
3. Heating lamp (Red)
4. Power lamp (yellow)
S. Cold tap (Blue)
6. Hot tap (Red)
7. Drip tray
8. Water Temperature Controller
9. Cooling switch (green)
10. Heating switch (red)
11. Radiator (Condenser)
12. Power cord set
13. Drain stopple
14. Earth wire
SCHEMATIC DIAGRAM OF VERTICAL COLD & HOT WATER DISPENSER
4
CHW4070 / CHW4070S
2. FEATURES
1. The dispenser supplies hot and cold temperature water to meet the demands of
people for drinking coffee or tea and having instant food or milk, cold drink, etc. It's
suitable for households, hotels, offices and schools, etc.
2. Up to five gallon (20 litres) bottle of pure water or RO-Purified water can be used
as the water source.
3. Powerful compressor refrigeration technology and exact temperature control
technology are adopted. It provides fast cooling and high efficiency.
4. The cooling tank and the heating tank are made of food grade stainless steel. They
are long-use, safe and sanitary.
3. INSTALLATION
1. In case it was transported or stored horizontally, place the dispenser in an upright
position for at least 4 hours before plugging it into the socket.
2. Remove the tamper seal label from the cap of the bottle. Do not remove the cap.
3. Gently insert the bottle vertically into the water guard and press the taps until the
water flows out from the RED (hot) tap.
4. Insert the power plug into a properly grounded socket, then turn on the switches
(DON'T TURN ON THE SWITCHES AT THE SAME TIME) to start the machine, the
heating lamp and the cooling lamp light up. It will stop or start working automatically
when the water temperature reaches the factory temperature settings.
5. If you do not want to dispense hot water, turn off the hot water switch on the back
of the unit (Red color)
6. If you do not want to dispense cold water, turn off the cold water switch on the
back of the unit (Green color)
4. WARNING
1. Replace bottle as soon as you notice it is empty. Unplug unit if bottle and tanks are
empty.
2. This unit dispenses water at temperatures that can cause severe burns. Avoid
direct contact with hot water.
3. Keep children away from unit while dispensing.
4. Never allow children to dispense hot water without proper and direct supervision.
5. Prior to use, this dispenser must be properly assembled and installed in
accordance with this manual.
6. This dispenser is intended for water use only. Do NOT use other liquids.
7. For indoor use only. Keep water dispenser in a dry place away from direct sunlight.
8. Install and use only on a hard, flat and levelled surface.
ENG
5
CHW4070 / CHW4070S
9. Do NOT place dispenser into an enclosed space
or cabinet. Always maintain its distance more than
15cm from the wall. There should be a distance of
15cm on the left and right side.
10. Make sure the adoption of the earth wire with
Three Pin-hole Socket and the Electric Leakage
Protector is available to avoid any electric shock.
11. Do not use an extension cord with your water
dispenser.
12. Always grasp plug and pull straight out from
outlet. Never unplug by pulling on power cord.
13. Do NOT use dispenser if the cord or plug is
damaged.
14. To protect against electric shock, do NOT
immerse cord, plug, or any other part of cooler in
water or other liquids.
15. Ensure dispenser is unplugged prior to cleaning.
16. Do not move it roughly. Do not incline it over 45°
17. Never allow children to use the dispenser
without proper and direct supervision. Unplug unit to prevent unsupervised use by
children.
18. In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
19. Maintenance and repair must be carried out by specialized technicians. It is
extremely dangerous to any person to fix the device or to dismantle it for repairing
purposes other than a qualified technician.
20. Do not let the power plug dangling over the edge in the reach of children.
5. CARE & CLEANING
Note: Do NOT use abrasive materials or chemical cleaners.
1. Clean cabinet surfaces with a soft cloth and warm soapy water. Dry it with a cloth
2. Brush off dust from the radiator (12) located at back of dispenser to improve
efficiency.
ENG
6
CHW4070 / CHW4070S
6. CLEANING COLD TANK
Recommended to be done every 2 to 3 months depending on the water type
1. Best to do prior to loading a fresh bottle
2. Turn off both switches on back
3. Unplug power cord
4. Remove water bottle
5. Place at least a 10 Litre bucket under the drain of the dispenser (found on the
back side)
6. Remove drain cap and silicon plug. Cold water will flow into the bucket. This
will be followed several seconds later by hot water at temperatures that can cause
severe burns. Avoid direct contact with hot water.
7. Place drain cap and silicon plug in a safe location so they are not lost.
8. Keep children away while draining the dispenser
9. Remove remaining water from the reservoirs by dispensing from both taps
10. Replace silicon plug and drain cap
11. Remove water guard (1) assembly by turning it counter clockwise.
12. Clean water guard assembly with a soft cloth using a cleaning mixture with 2%
cooking citric acid and 5 litres of clean water and then rinse the water guard and
place it on a clean cloth.
13. Pour remaining cleaning mixture into the tank
14. Dispense all cleaning mixture through the both taps
15. Wipe inside of reservoir and area around both taps with a soft cloth
16. Rinse system twice by dispensing 5 litres of tap water through both taps
17. Make sure all water has been dispensed.
18. Replace water guard assembly
19. Repeat INSTALLATION procedure as mentioned previously
7. TROUBLESHOOTING
Dispenser does not operate.
- Make sure the power cord is properly connected to a working outlet.
Water is leaking.
- Bottle may have a leak. Remove bottle and replace with new bottle.
No water is coming from the taps.
- Make sure the bottle is not empty. If so replace it.
- Make sure to push the water controls in fully.
Cold water is not cold.
- Make sure the switch is on and the plug is in the socket.
- Check the fuse and replace if necessary.
- It takes up to one hour after setup to dispense cold water.
- Make sure the back of the dispenser is at least 15cm from a wall
ENG
7
CHW4070 / CHW4070S
Hot water is not hot.
- Make sure the switch is on and the plug is in the socket.
- It takes 15-20 minutes after setup to dispense hot water.
- Check the fuse and replace if necessary.
Dispenser is noisy.
- Make sure dispenser is positioned on a level surface with proper distance from
walls or enclosure cabinet.
Water tastes bad.
- Drain water from reservoirs and replace bottle with a fresh one.
- Clean dispenser as per Care & Cleaning instructions.
Electrical Leakage.
- Make sure the earth wire and the leakage protector are available
8. TECHNICAL PARAMETERS
Power supply : 220-240V~ 50Hz
Total Power : 620W
Heating power : 530W
Cooling capability(L/h) : 2
Electricity leakage protection : I
Refrigerating current : 0.7A
Climate : T
Refrigerant code/Quantity : R134a/32g
9. CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return
and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
ENG
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
