Installation Guide
RK 00 Rough-In Kit for the W 00
The RK 00 Rough-In Bracket is designed to facilitate the
Installing the RK 00 Rough-In Kit:
installation of the McIntosh WS300 In-Wall Loudspeaker
System in new construction projects. The bracket provides a
solid metal mounting frame for extra support of the loud-
speaker and assures the cut out is the proper size. When in-
stalled vertically, the bracket will span 16 inch on center wall
studs. Refer to diagram below.
Note: Do not mount the flange opening closer than 1-1/4
inches from the stud to allow the clamping pieces to
swing freely for clamping the In-Wall Speaker
Assembly to the Rough-In Bracket and wallboard.
17 1/2”
44.45cm
16 1/4”
41.27cm
17 7/8”
45.40cm
13 5/16”
33.89cm
13 3/16”
33.50cm
McIntosh Part No. 04196600
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
1. Use a level to assure correct placement of the bracket.
2. Place the bracket against the studs with the flange fac-
ing outward.
3. Secure the bracket to the studs with 1 inch drywall
screws or 1 inch roofing nails (6 places).
