Shark NV70 Quick start guide

Type
Quick start guide

This manual is also suitable for

Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
A
Vacuum Pod
B
Motorized Floor Nozzle
C
Handle Assembly
D
Flexible Hose
E
Extension Wand
F
Upholstery Tool
G
5.5” Crevice Tool
WHAT’S INSIDE EMPTYING THE DUST CUP
MAINTENANCE
QUICK START GUIDE
Empty the dust cup after each use.
Cleaning the Brushroll
1 Detach the pod from
the floor nozzle.
2 Remove any blockages or buildup
from the airways in the nozzle.
Carefully cut away any fibers,
hair, or string wrapped around
the brushroll. Avoid damaging or
cutting the bristles.
Post-Motor
Filter
Foam
Felt
A
B
C
D
F
G
E
1 2
4 5 6
3
(Click)
(Click)
(Screw)
(Click)
(Click)
(Wrap)
(Click)
(Click)
DLX
Wash foam and felt filters
every 3 months and the
post-motor filter once a year
to keep the suction strong.
Rinse filters with water
only and allow to air-dry
completely. Tap loose dirt
from filters as needed
between washes.
2 WAYS TO CLEAN
FLOOR CLEANING
ABOVE-FLOOR CLEANING
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
SETTING I
For cleaning bare floors or
with accessories.
SETTING II
For carpet cleaning
with brushroll.
Attach desired cleaning
tool to hose or wand.
For additional parts and accessories, visit sharkaccessories.com
OR
OR
To clean above-floor areas, remove the
hose from the wand. Or for more reach,
remove the wand from the pod.
1
1 2
2 3
To activate brushroll, step on floor nozzle
and tilt handle back.
NV70Series_QSG_26_REV_Mv8
©2019 SharkNinja Operating LLC.
  • Page 1 1
  • Page 2 2

Shark NV70 Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI