AK6E OUTSIDE AIR KIT
For Wood Burning Fireplaces
Installation Instructions
The outside air vent is installed through a ventilated crawl space.
Install outside air vent termination in a location that would not
eventually be obstructed by bushes, snow or other obstructions.
Vent must be located near replace to make ex duct instal-
lation easier. Flex duct supplied measures approximately 10"
compressed and up to approximately 3 feet extended.
1. Locate air inlet cover plate on replace outer surround and
remove. Cut out any visible insulation that may obstruct
airow.
Tab in Notch
Sheet Metal
Screw
Air Inlet Tube
Remove
Knockout
Fireplace
2. Extend ex duct to attach air inlet tube. Insert inner tab
of inlet tube into mating slot next to opening. Place outer
tab of inlet tube over mating hole next to opening and
secure with screws previously removed from cover plate
in step 1.
Left Side Mounting
Shown
Secure to Collar with
Metal Tape, Screws or
Tie Straps (Not Supplied)
Insert Inner Tab
on Inlet Tube
into Slot on
Outer Surround
Flex Duct Extends
Up to 3 Feet
Floor
54030
Rev. G
06/09
Manufactured By:
FMI PRODUCTS, LLC
2701 S. Harbor Blvd.
Santa Ana, CA 92704
www.fmiproducts.com
/
