Instructions
ThermoLazer
™
Box Rear Heat Kit
Model 24H619
- For professional application of thermoplastic traffic marking compound materials
(reflective beads applied simultaneously with screeding) -
- For outdoor use only (not to be operated in rain or damp conditions) -
IMPORTANT SAFETY INSTRUCTIONS
Read all warnings and instructions in
manual 3A1319. Save these instructions.
3A1586C
ti22971a
EN
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
For patent information, see www.graco.com/patents
Original instructions. This manual contains English. MM 3A1586
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441
Copyright 2008, Graco Inc. is registered to I.S. EN ISO 9001
www.graco.com
Revision C - January 2014
Installation
1. Disconnect propane source.
2. Remove plug and copper gasket (ferrule) from fit-
ting.
3. Slide die heat kit over bead dispenser. Align slot on
bracket with bead dispenser screw head as shown.
Bolt hole should also be aligned.
4. Route hose as shown below.
5. Attach hose tee to fitting (21mm).
6. Install screed box rear burner lighting instructions
label (262) on screed shroud door below the torch
lighting instruction label (261).
ti14128a
ti17144a
ti17154b
ti22974a
ti22975a
ti22976a
ti14144b
-
1
-
2
Graco 3A1586C User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Graco 3A1320F User manual
-
-
-
-
-
-
-
-
-