Bogen CA17 User manual

Type
User manual
The Bogen Model CA17 Call Switch is a momentary-push switch designed
for use with PI/SI35A Intercom Systems in conjunction with the SCR25A.
When pushed and released once, a signal is sent to the MCP35A via the
SCR25A call-in module to annunciate the call-in on the SBA225.The room
must be equipped with a 25-volt speaker.
The CA17 is designed for flush-mounting in a standard single-gang outlet
box; connections are made as illustrated in the figure below.
EMERGENCY CALL SWITCH Model CA17
Model CA17 Connecting Diagram
50 Spring Street, Ramsey, NJ 07446 U.S.A.
201-934-8500; FAX: 201-934-9832
www.bogen.com
Printed in U.S.A. 0301
© 2003 Bogen Communications, Inc.
54-5919-01R3
Specifications subject to change without notice.
From MCP35A +12V Terminal.
Connect only the +12V Terminal to this point.
Do not connect a ground lead to this point.
Use second pin to jump +12V DC
to additional SCR25A panels.
The Bogen Model CA17 Call Switch is a momentary-push switch designed
for use with PI/SI35A Intercom Systems in conjunction with the SCR25A.
When pushed and released once, a signal is sent to the MCP35A via the
SCR25A call-in module to annunciate the call-in on the SBA225.The room
must be equipped with a 25-volt speaker.
The CA17 is designed for flush-mounting in a standard single-gang outlet
box; connections are made as illustrated in the figure below.
EMERGENCY CALL SWITCH Model CA17
Model CA17 Connecting Diagram
50 Spring Street, Ramsey, NJ 07446 U.S.A.
201-934-8500; FAX: 201-934-9832
www.bogen.com
Printed in U.S.A. 0301
© 2003 Bogen Communications, Inc.
54-5919-01R3
Specifications subject to change without notice.
From MCP35A +12V Terminal.
Connect only the +12V Terminal to this point.
Do not connect a ground lead to this point.
Use second pin to jump +12V DC
to additional SCR25A panels.
  • Page 1 1

Bogen CA17 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI