Allied Brass FR-1/16G-ABR, FR-1/16G-ABZ, FR-1/16G-BBR, FR-1/16G-GYM, FR-1/16G-ORB, FR-1/16G-PB, FR-1/16G-PC, FR-1/16G-PNI, FR-1/16G-SCH, FR-1/16G-VB Installation guide

Hello! I am an AI chatbot trained to assist you with the Allied Brass FR-1/16G-ABR Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

13.50

MOUNTING SCREW

LUG

Back Plate

Step 1:

Measure and mark for two holes in the wall based on the center to center of the Towel Bar.

Drill 1/2" holes into marks for Toggle Wings and screws.

Drill Holes into the Wall

Mounting of Screws

Screws are inserted through the mounting lug so that it protrudes through other side

of backplate.

Step 2:

FR-1G-16

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.

WING NUT INITIAL POSITION

-SQUEEZED OFF TO FIT DRILLED HOLE

IN WALL

WING NUT (INSTALLED)

WALL

MOUNTING SCREW

BACK PLATE

MOUNTING LUG

WALL

Towel Bar

Set Screw

Step 3:

Wing nut is attached to screw and pushed into wall. Make sure the head of the screw fits

inside the countersink of the mounting lug. Make same process on mounting the other

Back Plate.

Wing Nut Installation

Tower Bar Installation

Backplates are tightened against wall and Towel Bar are attached to mounting lug with the

use of set screws.

Step 4:

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.