Conrad energy Non-standard battery (rechargeable) 18650 Li-ion 18650 USB 3.7 V 1400 mAh 2 pc(s) Operating instructions

Type
Operating instructions
b) Persons and Product
Do not use a USB 2.0 (or below) port to charge the product.
Never pour any liquids over electrical devices or place objects lled with liquid
next to the product. If liquids or objects do get into the interior of the product,
discontinue use and take the product to a repair centre.
Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. Allow the
product to reach room temperature before connecting it to an appliance. This may
take several hours.
Never leave the product unattended during use.
The battery housing warms up during use. Ensure that there is sufcient
ventilation. Do not cover the battery housing!
c) Rechargeable batteries
The battery cell is built into the product and cannot be replaced.
Never attempt to damage the rechargeable battery. Damaging the casing of the
rechargeable battery may cause an explosion or a re!
Never short-circuit the contacts of the rechargeable battery. Do not throw the
battery into open ames. This presents a re hazard and may cause an explosion.
Charge the battery regularly, even when you are not using it. You do not need to
discharge the battery before charging it.
Never leave the battery unattended when it is charging.
Never cover the battery when it is in use. The battery may generate a small
amount of heat during charging.
When connecting the battery to a USB extension cable, place the battery on a
heat-resistant surface.
Operation
Check the battery level before each use. Do not short-circuit the USB connection.
Ensure that the battery is fully charged before each use. Before inserting the battery
into an appliance, ensure that the appliance's specications conform to the battery
specications listed in the technical data section. Always read the appliance's
operating instructions carefully.
a) Charging the battery
Charge the batteries when the battery level is low or when you notice a drop in performance.
Pull the protective cap off the end of the battery.
Insert the USB-A connector into a USB port on a computer or another suitable USB power
source, such as a USB power adapter. Charging will begin when the USB power source
delivers a current. The LED indicator will turn red to indicate that the battery is charging.
Unplug the battery from the USB power source when the LED indicator turns blue (this
indicates that the battery is fully charged).
It takes about 3 hours to fully charge the battery at the maximum input current (see
"Technical data"). The actual charging time required depends on the battery level
and the charging current. If you only use the batteries occasionally, we recommend
that you charge them every three months to ensure that they retain their maximum
capacity.
If you do not unplug the battery when it is fully charged, the battery will switch to
trickle charge (the amount of power delivered to the battery is equal to the battery's
self-discharge).
b) Using the battery
Replace the protective cap by inserting it onto the USB-A connector.
Insert the battery into an appliance in accordance with the appliance's instructions.
When the battery is empty, remove it from the appliance in accordance with the instructions.
c) Overload, overdischarge and short-circuit protection
The battery automatically switches off in the event of an overload.
The battery automatically switches off in the event of a deep discharge. If this occurs, remove
the battery from the appliance and connect it to a USB port to charge.
The battery switches off automatically in the event of a short circuit. If this occurs, remove the
battery from the appliance and connect it to a USB port to charge.
d) Storage and transport
Replace the protective cap when you are not using the battery.
Ensure that the cap is connected properly and that there is no dirt trapped inside.
Cleaning
Before cleaning the product, remove the battery from the connected appliance (or unplug it
from the USB port).
Operating Instructions
18650 Battery with USB connector
Item no. 1525536
Intended use
These portable rechargeable batteries are designed to operate devices that use a 18650
battery and conform to the specications stated in the technical data section. Each battery
features an LED battery level indicator and is protected against overcharge, overload and short
circuits.
The battery must only be charged indoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety reasons, you must not rebuild and/or modify this product. Using the product for
purposes other than those described above may damage the product. In addition, improper
use can cause hazards such as short circuits, re and electric shocks. Read the instructions
carefully and store them in a safe place. Make this product available to third parties only
together with its operating instructions.
This product complies with statutory national and European regulations. All company names
and product names are trademarks of their respective owners. All rights reserved.
Delivery content
2 x 18650 batteries with USB connector
Operating instructions
Up-to-date operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
on this page. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in the triangle is used if there is a risk to your health,
e.g. due to an electric shock.
This symbol is used to highlight important information in these operating instructions.
Always read this information carefully.
This symbol indicates special information and advice on how to use the product.
Safety instructions
Read the operating instructions and safety information carefully. Failure to
follow the safety instructions and information on proper handling in this
manual will void the warranty/guarantee. The manufacturer shall not be liable
for any personal injury or damage to property arising due to failure to follow
these instructions.
a) General information
This product is not a toy. Keep it out of the reach of children and pets.
Do not leave packaging material lying around carelessly, as it may present a
safety hazard for children.
Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, ammable gases, vapours and solvents.
Do not place the product under any mechanical stress.
If it is no longer possible to operate the product safely, discontinue use and prevent
unauthorized use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
Always handle the product carefully. Jolts, impacts or a fall even from a low height
may damage the product.
Always observe the safety and operating instructions of any other devices which
are connected to the product.
Consult a technician if you are not sure how to use or connect the product.
Maintenance, modications and repairs must be done by a technician or an
authorized repair centre.
If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE. *1525536_v1_0117_02_DS_m_4L_(1)
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could
damage the casing or cause the battery to malfunction.
Do not immerse the product in water.
Clean the protective cap from time to time.
The product does not contain any components that require maintenance. Never attempt to
open or disassemble the battery.
Use a dry lint-free cloth to clean the product. Do not press too hard on the housing, as this
can lead to scratch marks.
Dust can be easily removed using a soft and clean long-haired brush.
Disposal
a) Product
Electronic devices are recyclable waste and must not be disposed of in household
waste. Always dispose of the product according to the relevant statutory regulations.
b) Rechargeable batteries
As the end user, you are required by law to return all used rechargeable batteries;
they must not be disposed of in household waste! Rechargeable batteries that
contain hazardous substances are labelled with this symbol to indicate that disposal
in household waste is forbidden. The abbreviations for heavy metals in batteries
are: Cd = Cadmium, Hg = Mercury, Pb = Lead (indicated on rechargeable batteries,
e.g. below the trash icon on the left).
Used rechargeable batteries can be returned to local collection points, our stores or
rechargeable battery retailers.
By returning rechargeable batteries, you full your statutory obligations and contribute to the
protection of the environment.
Technical data
Input voltage/current ..................... 5 V/DC, 0.7 A
Rechargeable battery ................... Lithium-Ion (Li-Ion) 3.7 V / 1400 mAh
Charging time ............................... 3 h (full charge)
Operating conditions ..................... 0 to +45 °C, 10 – 85 % RH
Storage conditions ........................ -10 to +60 °C, 10 – 85 % RH
Dimensions (Ø x L) ....................... 18 mm x 66 mm
Weight .......................................... 38 g
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Conrad energy Non-standard battery (rechargeable) 18650 Li-ion 18650 USB 3.7 V 1400 mAh 2 pc(s) Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI