Page is loading ...
1
2. DC Output(12V/6A Max)
5. Power button/ Flashlight button
1. Jumping port
3. Type-C Input/Output(5V/3A Max)
4. USB Output 1 (QC 3.0)|USB Output 2(5V/2.1A)
6. Battery Indicator
7. Flashlight
At a Glance
2
Power Indicator Light Description
Press the Switch/Power button to check the battery
level.
Recharging the jumper starter
Charging with an AC adapter(AC adapter is not included)
1.Connect the Type-C input port of the jump starter to
the USB port of the wall charger through the Type-C
cable included.
2. Plug the AC adapter into universal socket.
Charging Time:
● 5v 1A charger takes 12.5 hours
● 5v 2A charger takes 6.5 hours
● 5v 3A charger takes 4 hours
During charging, the indicators flash cyclically and show
real-time power. All lights will go out when it is fully
charged or charging is paused.
Indicator
Battery Level
1 Flashing
0%
1 Solid
25%
2 Solid
50%
3 Solid
75%
4 Solid
100%
Car Jump Starter
AC Adapter
Type-C port
3
It is recommend to use above 5V 2A adapter like phone
adapter to charge the jump starter.
2. Insert jumper cables into jumping port.
3. Connect red clamp to positive (－) terminal and
black clamp to negative (－) terminal of the car battery.
1. Switch on your starter and make sure it s over 25％
charged
4
4. Start your engine.
5. Remove clamps and pack away.
Instrution to connect to clamps
Battery life in good condition
5
Battery life in low condition
Manual Overload Button on the Clamps
Instruction of LED Indicator Light
Smart Battery Clamps
WARNINAG
6
Charging your phone or tabet
Connect the jump starter to your device via usb
cable (Not included)
Short press power button
Using the Flashlight
7
Specifications
1. Hold to turn on
2. Press to toggle flash/turn off
8
Attention
Customer Service
/
