Enclume
HOOP LOG RACK WITH HANDLE
Model LR34
Quality, design, strength and function –
Features we build in you can count on.
Congratulations for acquiring one of the finest
Hearthside log racks made.
WARNING:
READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK.
:
ASSEMBLY INSTRUCTIONS for LR34
Hardware included:
4 – 5/16" x 5/8"Button head screws
2 – 5/16" x 1/2" Button head screws
1 – 3/16" Allen wrench
Components included:
2 – Hoop body pieces
2 – Legs
2 – Crossbars
1 – Handle
ASSEMBLY STEPS
1) Place a hoop body piece on top of and parallel to one of the legs. Place the crossbars perpendicular to
the hoop body piece aligning the holes and insert one of the four 5/16" x 5/8" button head screws
through all 3 holes on both sides (see figure 2). Repeat this step on the other side of the hoop in the
same leg. The screws should be inserted from the top down toward the floor. Tighten the screws only
finger tight while assembling. Repeat for the other hoop and leg.
2) Using the 5/16" x 1/2" button head screws, attach the handle on the top of the hoops aligning the holes
and inserting the screw from the top down.
3) Square up your rack and tighten all the screws firmly.
See reverse side for exploded drawing and warranty information.
Enclosed you will find everything needed for the
assembly and use of your storage rack. Two
people make assembly and installation easier.
The parts and hardware included are:
