Giagni MM101-ORB Installation guide

Wall Mounted Mirror

Installation Instructions

Contents (quantity):

Mirror Assembly (1)

Mounting Plate (1)

Masonry Anchors (2)

Screws (2)

Cap Nuts (2)

MM101

Series

1. Remove the mounting plate from the mirror assembly

by unscrewing the cap nuts. Do not remove the pre-assem-

bled screws on the mounting plate.

2. Choose the mounting position. Height is the most critical

since the mirror does not adjust up and down, just tilts. Allow

for a comfortable position while standing with the mirror

nearly at full extension. Mounting the mirror onto a wall

stud is HIGHLY recommended.

3. Place the mounting plate on the wall in the preferred

position and mark the location of the two holes. Be sure the

holes are plumb (vertically level).

4. For drywall: Drill two 1/8” holes to confirm stud location. If

using studs, secure mounting plate to stud with two

screws. If not using studs, heavy-duty wall anchors are

recommended (not included).

5. For masonry walls, drill 5/16” holes and use masonry

anchors and screws (included).

6. Place mirror assembly onto the threaded studs on the

mounting plate, and secure with the cap nuts.

548 So. Columbus Avenue Mount Vernon, NY 10550

Customer Service: 1-888-560-5222

A QMI, Inc. Brand

Download PDF