2. Blaze King
  3. Clarity 26 FS SP Fan Kit (S.Z5177.SP)

Blaze King Clarity 26 FS SP Fan Kit (S.Z5177.SP) Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Blaze King Clarity 26 FS SP Fan Kit (S.Z5177.SP) Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
180-Z5177-SP v1.02 E October 12, 2017
Manufactured By
Valley Comfort Systems Inc., 1290 Commercial Way, Penticton, BC, V2A 3H5, Canada
Phone: 250-493-7444 Fax: 250-493-5833 www.blazeking.com info@blazeking.com
S.Z5177.SP FAN KIT
for CLARITY 26 FS SP (Standing Pilot)
(S.CL26.FS.SP)
The blower will only come on when the fi replace is up to temperature
(approximately 10-15 minutes). Fan speed control sequence is off , then
maximum to minimum. The speed of the fan can be decreased by turning the
knob clockwise . The speed of the fan can be increased by turning the knob
counterclockwise. The blower will continue to operate after the burner is turned
off (approximately 15-20 minutes). To turn the blower off manually, turn the fan
control knob counterclockwise until it “clicks”.
180-Z5177-SP v1.02 E October 12, 2017
Page 2
S.Z5177.SP FAN KIT for CLARITY 26 FS SP
1. Turn off gas (see gas valve).
2. Feed power cord assembly wires through slot and
plastic bushing of leg.
3. Feed power cord assembly wires through the
control housing’s plastic bushing.
4. Screw the top of the power cord plate to the leg.
5. Screw the bottom of the power cord plate to the leg.
6. Lay blower assembly on blower box between legs.
Slide the fan rheostat into the control plate hole as
shown.
GAS VALVE
180-Z5177-SP v1.02 E October 12, 2017
Page 3
S.Z5177.SP FAN KIT for CLARITY 26 FS SP
7. Attach the star washer and nut to the rheostat peg
on the front of the control panel.
8. Slide the control knob onto the rheostat post.
9. Slide the snap disk into the snap disk bracket that
is above the rheostat on the fi rebox bottom.
Ensure the snap disk tabs are both seated into the
bracket.
10. Connect the black “B” wire front the rheostat with
the black “B” wire from the power cord.
11. Connect the black “W” wire from the fan assembly
with the white “W” wire from the power cord.
12. Position the fan into place as shown.
Ensure the side tabs are between the support panel
and the fi rebox bottom panel.
180-Z5177-SP v1.02 E October 12, 2017
Page 4
S.Z5177.SP FAN KIT for CLARITY 26 FS SP
13. Screw the fan assembly to the appliance:
2 screws (1 each side) into the fi rebox bottom.
4 screws to secure the back.
14. Feed the power cord ground wire through
Screw the power cord ground wire to the wire cover
and control housing side.
Screw in remaining 3 screws to fasten wire cover.
CLARITY 26 FS SP WIRING
Female .250
Male .250
6" blk
8" blk
blk
wht
120 VAC
SUPPLY
rheostat
2" blk
2"wht
M
T
12" blk12" blk
thermal
sensor
B
W
W
B
/