DIRECT WICKER PAD-3233B-P Operating instructions

TABLE ASSEMBLY INSTRUCTIONS . DIRECT WICKER

TABLE

ASSEMBLY INSTRUCTIONS

BEFORE YOU START ASSEMBLING YOUR

FURNITURE:

CHECK THAT YOU HAVE ALL THE

PIECES LISTED ON THE LEFT HAND

SIDE.

LAY A CLEAN SHEET ON A FLAT

SURFACE BIG ENOUGH TO ASSEMBLE

YOUR FURNITURE ON IN ORDER TO

PROTECT YOUR FURNITURE.

Lay the tabletop (A) down so the frame is facing upwards.Withthe slit facing

upwards, attach chair legs (B), to the table top by aligning the screw holes

with thosein thetable top (A) . Insertscrews(E)throughthe washerandinto

theholesandlooselytightenwiththeallenkey(F).

Theninserttableleg(C)intopositionovertheslitoftableleg(B)andalignthe

screwholeswiththeholesinthetabletop(A).Insertscrews(E)throughthe

washerandintotheholesandlooselytightenwiththeallenkey(F)inthe

locationsshownintheimagebelow.

Attach both the table legs together by placing the bracket (G) over the screw

holes on the bottomof table leg(B & C) as shown intheaboveimage and

inserting the three remaining screws (E) through the washers and into the

bracketandtablelegs.Fullytightenusingtheallenkey(F).

Fully tighten all of thescrews in the table usingthe allenkey (F) then place the

screwcapsoverallofthescrews.

TABLE ASSEMBLY INSTRUCTIONS . DIRECT WICKER

Turnthetableuprightandplacethetemperedglass(D)

overthetabletop.

This manual is also suitable for

Download PDF