Hydro Crunch KDCMHR17-630-3K Operating instructions

Hydro Crunch
Brand
Hydro Crunch
Model
KDCMHR17-630-3K
Type
Operating instructions

This manual is also suitable for

Instruction Manual
Double Ended
Cool Tube Hood Reflector
Parts List
3 –Middle reflector
4 –End reflectors
1 –Cool Tube
4 –Corner steel plates
30–M4 nuts
46–M4*8 Wing screws
Reflector Assembly
How to Assemble
1. Use 28 sets wing screws and 12 nuts to attach the middle aluminum and side aluminum.
2. Use rest 18 sets wing screws and nuts to connect the middle steel plates to the side aluminum
reflector.
3. Finish the assembly and hang the reflector with rope hangers.
Lamp Installation
1. Open up both the cover of lamp holders.
2. Install the lamp after the lamp is locked by latch.
3. Once lamp is positioned correctly close the cover of the lamp holders to secure and lock the lamp in
place.
4. Installing the double ended lamp within the lamp holders shown in the following photos below.
Please note: During installation try to minimize excessive handling of the lamp to minimize fingerprints and
oils left on the lamp. If the lamp needs cleaning use a soft dry cotton cloth to wipe of finger prints or oils.
ATTENTION：Please make sure the wire of the lamp is straight when you install the lamp. If not, the lamp
will not connect securely with the socket.
1 Year Limited Warranty Service
If the product will not work after you have read the troubleshooting guide and practiced the
troubleshooting options, you are advised to return the Hydro Crunch™ light system to the retailer you
purchased it from. The dealer will be able to examine the light and test its components. If they are not able
to repair the light, they will return it to us for examination and repair/replacement. Do not attempt to
repair any product on your own, as serious injury or death may result. If the retailer is not able to help you
and the light is still under manufacturer’s warranty, you may contact us for technical support. In some cases,
you will be issued an RMA# (return merchandise authorization number) to return the unit for factory repair.
Complete the warranty form below and return the light with all original packaging, your receipt of purchase,
and a valid RMA# to the address below. Please pack and ship the light in its original packaging. If it is
damaged in shipment we cannot be responsible and the warranty may be voided. Once we receive RMA
package, it will be repaired or replaced and shipped back to you. Please note if an additional warranty was
purchased and include the extended warranty sales receipt with your return.
RETURN FORM
Include the following if returning:
Proof of purchase
This completed form
RMA# on the outside of the box
Extended warranty receipt
Return Merchandise Authorization Number (Required): ___________________________________
Contact Name: _____________________________________________________________________
Address: __________________________________________________________________________
__________________________________________________________________________________
Phone #: __________________________________________________________________________
Email Address: _____________________________________________________________________
Please give a brief description of your technical issue: _____________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
SEND TO:
Hydro Crunch
20651 Golden Spring Drive Suite 115
Walnut, CA 91789
714-516-8176
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hydro Crunch KDCMHR17-630-3K Operating instructions

Hydro Crunch
Brand
Hydro Crunch
Model
KDCMHR17-630-3K
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents