UTILITY VEHICLE UTILITY RACK
MODEL: UVUR1 (Polaris Ranger), UVUR2 (Kawasaki Mule), UVUR3 (Polaris Ranger
400) & UVUR4 (Honda Big Red), UVUR5 (Kubota 500) & UVUR6 (Kubota 900)
READ ALL INSTRUCTIONS BEFORE INSTALLING UTITLITY RACK.
NOTE: Failure to read instructions before use could result in injury or death.
Instructions for Installation and Use:
Fig.1
Fig.2
Contents: See Fig. 1
2ea. Utility rack side frames w/
eyebolts installed.
1ea. Rear horizontal bar w/ load
stops and eyebolts. (2 pcs.)
1ea. Front horizontal bar. (2 pcs.)
2ea. Load securing straps.
4ea. 5/16 x 2-1/2 bolts.
2ea. 5/16 x 1-3/4 bolts.
6ea. 5/16 locknuts.
20ea. 5/16 flat washers.
4ea. ¼ x 1-1/4 lag screws.
4ea. ¼ x 1-1/4 bolts.
4ea. ¼ locknuts
Assemble front and
rear horizontal bars
using 5/16 x 1-3/4 bolts,
flat washers, and
locknuts. Tighten
securely. (see Figs 2 &
3). NOTE: Fig.4 shows
assembled rear bar and
Fig.5 shows assembled
front bar.
Fig.3
Fig. 4
Fig.5
Fig.6 Fig.7
Attach rear horizontal
bar, (Fig.6), and front
horizontal bar, (Fig.7),
to utility rack side
frames using 5/16 x 2-
1/2 bolts, flat washers,
and locknuts.
Fig.8 Fig.9
Fig.10 Fig.11
Fig.12
Tighten all bolts
securely. (Figs.
8 & 9)
Place assembled rack
onto bed rails in the
desired position and
mark holes for drilling,
(Fig.10). Move rack to
expose marks and drill
holes in bed rail. (Fig.
11). NOTE: If lag
screws are to be used,
drill 1/8” hole. If
underside of bed rail
can be reached and
bolts are used, drill ¼”
hole.
Place utility rack over
drilled holes and secure
to bed rails using the ¼”
x 1-1/4” lag screws and
flat washers or ¼ x 1-
1/4 bolts, flat washers,
and locknuts.(Fig.12).
NOTE: To avoid
stripping plastic bed
rails, do not over-tighten
lag screws.
: PLEASE READ AND FOLLOW ALL INSTRUCTIONS AND WARNINGS FURNISHED
WITH #UVUR UTILITY RACKS.
: MAXIMUM WEIGHT CAPACITY 100 LBS.
: NEVER ALLOW ANYONE TO SIT OR CLIMB ON UTILITY AT ANY TIME.
: NEVER USE UTILITY RACK FOR ANY PURPOSE OTHER THAN INTENDED USE.
: NEVER TRANSPORT A LOAD ON UTILITY RACK WITHOUT IT BEING PROPERLY
SECURED.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * (866) 649-1918 * www.greatdayinc.com
Secure load to
utility rack by
attaching “S”
hooks on straps to
eyebolts on utility
rack, (Fig.13), and
pulling tight
through cam
buckle, (Fig.14).
/
