Siemens FSPHONE4X is a hardwired surge protector for telephone, DSL, or modem connected electronics in residential and light commercial applications. It protects against electrical power surges that can enter through the main telephone connection and is equipped with a failsafe device to permanently ground the telephone line in the event of a power cross. The FSPHONE4X is designed for indoor applications or can be mounted inside another weatherproof enclosure for outdoor mounting applications.
Siemens FSPHONE4X is a hardwired surge protector for telephone, DSL, or modem connected electronics in residential and light commercial applications. It protects against electrical power surges that can enter through the main telephone connection and is equipped with a failsafe device to permanently ground the telephone line in the event of a power cross. The FSPHONE4X is designed for indoor applications or can be mounted inside another weatherproof enclosure for outdoor mounting applications.
usa.siemens.com/surge
www.siemens.ca/surge
FSPHONE & FSPHONE4X
User Manual - English (USA), English (Canada), French (Canada)
Manuel d’ Installation
Surge Protection for Telephone or Modem Connected Electronics
Features and Benefits
▪ UL listed
▪ Hardwired Modem/Fax/DSL
protection
▪ Easy to install
▪ Exceptionally fast response time
▪ Low insertion loss
▪ Available with or without enclosure
▪ 5-Year product warranty*
The Siemens FSPHONE is a 2 pair,
hardwired surge protector for telephone,
DSL or modem connected electronics
in residential and light commercial
applications. The FSPHONE protects
against electrical power surges that
can enter through the main telephone
connection and is equipped with a
failshort device to permanently ground
the telephone line in the event of a power
cross. The FSPHONE is designed for
indoor applications or can be mounted
inside another weatherproof enclosure
for outdoor mounting applications.
The FSPHONE4X includes the FSPHONE
plus a weatherproof enclosure to
facilitate indoor or outdoor applications.
The enclosure is molded of temperature
and humidity resistant thermoplastic to
resist cracking and discoloration. The
cover can be secured with a tie wrap or
similar locking device.
For total home protection please use
FirstSurge
TM
to protect your incoming AC
Power lines and FSCATV to protect your
coaxial connections.
User Manual - USA (English)
1
2
Technical Specifications
AC SURGE PROTECTION
Catastrophic Surge Circuit Yes
Spike Capacity 200 Amps
Let Through Voltage <270 V
Overcurrent Protection Yes
Response Time <1 nanosecond
Environmentally Sealed Yes
AGENCY APPROVALS & WARRANTY
UL/cUL Listings
497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors
Yes
Product Warranty 5 Years
CATALOG NUMBER
FSPHONE 2 pair protection module
FSPHONE4X 2 pair protection module 1 Weatherproof Enclosure
UL Model No. - SATH2 & SATHW2
* See www.usa.siemens.com/surge for warranty details.
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
This device can be used indoor (FSPHONE), or outdoor when installed in weatherproof
housing(FSPHONE4X). Failure to follow installation instructions can result in personal
injury and/or equipment damage not covered by warranty.
FSPHONE – For indoor use:
▪ FSPHONE protects 2 pairs (1 pair per protector module) and is intended for
indoor use only, without additional housing.
▪ Attach securely to mounting surface.
▪ Install ground wire, and if applicable, service shield, under top center nut of
mounting bracket and tighten nut securely.
▪ Connect one pair (tip and ring) under the bottom nut on each protector
module, tip on one post, ring on the other.
▪ Connect the customer wiring, tip and ring, under the top nut on the same
protector module (protector is wired in parallel)
▪ Check all wiring for loose connections and shorting or broken wires.
FSPHONE4X – For outdoor use:
▪ Mount weatherproof housing securely to flat surface.
▪ Conductors will enter and exit from the flexible grommet located at bottom of
enclosure.
▪ Follow instruction above for FSPHONE connections.
▪ Secure enclosure with tie wrap or similar locking device.
▪ The FSPHONE4X is a Parallel Device.
Installation Instructions:
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers
3
User Manual - Canada (English)
Features and Benefits
▪ cUL listed
▪ Hardwired Modem/Fax/DSL
protection
▪ Easy to install
▪ Exceptionally fast response time
▪ Low insertion loss
▪ Available with or without enclosure
▪ 5-Year product warranty*
The Siemens FSPHONE is a 2 pair,
hardwired surge protector for telephone,
DSL or modem connected electronics
in residential and light commercial
applications. The FSPHONE protects
against electrical power surges that
can enter through the main telephone
connection and is equipped with a
failshort device to permanently ground
the telephone line in the event of a power
cross. The FSPHONE is designed for
indoor applications or can be mounted
inside another weatherproof enclosure
for outdoor mounting applications.
The FSPHONE4X includes the FSPHONE
plus a weatherproof enclosure to
facilitate indoor or outdoor applications.
The enclosure is molded of temperature
and humidity resistant thermoplastic to
resist cracking and discoloration. The
cover can be secured with a tie wrap or
similar locking device.
For total home protection please use
FirstSurge
TM
to protect your incoming AC
Power lines and FSCATV to protect your
coaxial connections.
2
Technical Specifications
AC SURGE PROTECTION
Catastrophic Surge Circuit Yes
Spike Capacity 200 Amps
Let Through Voltage <270 V
Overcurrent Protection Yes
Response Time <1 nanosecond
Environmentally Sealed Yes
AGENCY APPROVALS & WARRANTY
UL/cUL Listings
497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors
Yes
Product Warranty 5 Years
CATALOG NUMBER
FSPHONE 2 pair protection module
FSPHONE4X 2 pair protection module 1 Weatherproof Enclosure
UL Model No. - SATH2 & SATHW2
* See www.siemens.ca/surge for warranty details.
Installation Instructions:
4
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
This device can be used indoor (FSPHONE), or outdoor when installed in weatherproof
housing (FSPHONE4X). Failure to follow installation instructions can result in personal injury
and/or equipment damage not covered by warranty.
FSPHONE – For indoor use:
▪ FSPHONE protects 2 pairs (1 pair per protector module) and is intended for
indoor use only, without additional housing.
▪ Attach securely to mounting surface.
▪ Install ground wire, and if applicable, service shield, under top center nut of
mounting bracket and tighten nut securely.
▪ Connect one pair (tip and ring) under the bottom nut on each protector
module, tip on one post, ring on the other.
▪ Connect the customer wiring, tip and ring, under the top nut on the same
protector module (protector is wired in parallel)
▪ Check all wiring for loose connections and shorting or broken wires.
FSPHONE4X – For outdoor use:
▪ Mount weatherproof housing securely to flat surface.
▪ Conductors will enter and exit from the flexible grommet located at bottom of
enclosure.
▪ Follow instruction above for FSPHONE connections.
▪ Secure enclosure with tie wrap or similar locking device.
▪ The FSPHONE4X is a Parallel Device.
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers
Données techniques
Caractéristiques et
avantages
▪ Homologation cUL
▪ Protection câblée pour modem/
télécopieur/ligne numérique
▪ Facile à installer
▪ Temps de réponse
exceptionnellement rapide
▪ Affaiblissement d’insertion peu
important
▪ Avec ou sans boîtier
▪ Produit garanti 5 ans*
Le suppresseur de surtensions FSPHONE
câblé à deux paires de Siemens est
destiné à la protection d’appareillages
électroniques pour la maison et les petites
applications commerciales connectés
par téléphone, ligne numérique ou
modem. Le FSPHONE protège contre
les surtensions qui peuvent provenir du
raccordement téléphonique principal.
Il comporte une sécurité intégrée qui
met à la terre en permanence la ligne
téléphonique, en cas d’inversion de
polarité. Conçu pour les applications
intérieures, le FSPHONE peut aussi être
installé à l’extérieur, dans un boîtier
étanche.
L’ensemble FSPHONE4X comprend le
suppresseur de surtensions FSPHONE
et un boîtier étanche, afin de faciliter
l’installation à l’intérieur comme à
l’extérieur. Fait de thermoplastique
résistant aux écarts de température et
à l’humidité, le boîtier résiste ainsi au
fendillement et à la décoloration. Son
couvercle peut être fixé à l’aide d’une
attache autobloquante ou d’un dispositif
de blocage semblable.
Pour assurer la sécurité complète d’une
maison, ajoutez le dispositif FirstSurge
TM
,
qui protège les circuits d’alimentation c.a.,
ainsi que l’ensemble FSCATV, qui protège
les liaisons par câble coaxial.
Manuel d’installation - Canada (Français/French)
5
Données techniques
PROTECTION CONTRE LES SURTENSIONS C.A.
Circuit antisurtension catastrophique Oui
Tension de courant de choc 200 Amps
Niveau de tension <270 V
Protection en surintensité Oui
Temps De Réponse <1 nanosecond
Hermétique Oui
HOMOLOGATIONS ET GARANTIE
Homologation UL/cUL 497A
Meets Telcordia (formallly Bellcore) GR-974-CORE
Requirements for Telecommunications Line Protectors
Oui
Garantie 5 ans
NUMERO DE PIÈCE
FSPHONE 2 paires module de protection
FSPHONE4X 2 paires module de protection 1 intempéries boîtier
UL Model No. - SATH2 & SATHW2
* Voir le site www.siemens.ca/surge pour les modalités de la garantie.
Instructions d’installation
6
NE PAS INSTALLER PENDANT UN ORAGE.
Le dispositif FSPHONE peut être utilisé à l’intérieur comme à l’extérieur, s’il est placé dans
un boîtier étanche (FSPHONE4X). Veuillez suivre les directives d’installation, à défaut
de quoi, vous vous exposez à des blessures et/ou risquez de causer des dommages à
l’équipement non couverts par la garantie.
FSPHONE – Pour usage intérieur :
▪ Le dispositif FSPHONE, qui protège deux paires de câbles (une par module de
protection), est destiné à un usage intérieur seulement, à moins de le poser
dans un boîtier additionnel.
▪ Le fixer solidement à la surface de montage.
▪ Installer le câble de mise à la terre et, s’il y a lieu, le bouclier, au moyen de
l’écrou central supérieur du support de fixation, puis serrer l’écrou fermement.
▪ Raccorder une paire (tête et nuque) sous l’écrou inférieur de chaque module
de protection, la tête sur une borne, la nuque sur l’autre.
▪ Raccorder le câblage client, tête et nuque, sous l’écrou supérieur du même
module de protection (le module est câblé en parallèle).
▪ Vérifier tout le câblage pour vous assurer qu’il est bien raccordé et qu’il n’y a
pas de connexion lâche, de fil endommagé ou de risque de court-circuit.
FSPHONE4X – Pour usage extérieur :
▪ Fixer solidement le boîtier étanche sur une surface plane.
▪ Les conducteurs entreront et sortiront par le
passe-câble souple situé à la base du boîtier.
▪ Suivre les directives ci-dessus pour raccorder le FSPHONE.
▪ Bloquer le couvercle du boîtier avec une attache autobloquante ou un moyen de
fixation semblable.
▪ L’ensemble FSPHONE4X est un dispositif parallèle.
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers
Siemens Industry, Inc.
5400 Triangle Parkway
Norcross, GA 30092
888-333-3545
Siemens Canada Limited
1577 North Service Road East
Oakville, ON L6H 0H6
888-333-3545
info@purgethesurge.com
European Authorized Representative
Obelis s.a.
Boulevard Général Wahis 53
1030 Brussels, BELGIUM
Tel: +(32) 2. 732.59.54
Fax: +(32) 2. 732.60.03
E-Mail: [email protected]
Order No. RPIM-FSPHO-0815 | Printed in USA |
© 2015, Siemens Industry, Inc.
usa.siemens.com/surge
www.siemens.ca/surge
7.30.15.lh #9059
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Siemens FSPHONE4X Installation guide
- Type
- Installation guide
- This manual is also suitable for
Siemens FSPHONE4X is a hardwired surge protector for telephone, DSL, or modem connected electronics in residential and light commercial applications. It protects against electrical power surges that can enter through the main telephone connection and is equipped with a failsafe device to permanently ground the telephone line in the event of a power cross. The FSPHONE4X is designed for indoor applications or can be mounted inside another weatherproof enclosure for outdoor mounting applications.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- français: Siemens FSPHONE4X Guide d'installation
Related papers
Other documents
-
Stanley ST-22-240-E User manual
-
Stanley ST-309-401-E Owner's manual
-
Stanley ST-02-240-E User manual
-
-
-
Channel Vision C-0410 Datasheet
-
Stanley ST-53-231-E User manual
-
-
Gardner Bender SM02B211 User manual
-
ProTemp PT-70-SS-EU User's Manual And Operating Instructions