Longshine LCS-GS8116 User manual

Category
Network switches
Type
User manual

This manual is also suitable for

Longshine LCS-GS8116 is a powerful, high-performance Gigabit Ethernet switch featuring 16x 10/100/1000Mbps RJ-45 Gigabit Ethernet ports. It supports auto MDI/MDI-X function, allowing for easy and flexible switch-to-switch connections. The store-and-forward switching mode eliminates network errors and latency, while the 9K jumbo frame support enhances network performance. With its plug-and-play design, the switch is easy to install and configure without requiring any additional software.

Longshine LCS-GS8116 is a powerful, high-performance Gigabit Ethernet switch featuring 16x 10/100/1000Mbps RJ-45 Gigabit Ethernet ports. It supports auto MDI/MDI-X function, allowing for easy and flexible switch-to-switch connections. The store-and-forward switching mode eliminates network errors and latency, while the 9K jumbo frame support enhances network performance. With its plug-and-play design, the switch is easy to install and configure without requiring any additional software.

16/24-Port Gigabit Switch
User’s Manual
English
Deutsch
Español
Français
Italiano
Polski
1
The device is a powerful, high-performance Gigabit Ethernet switch,
with all ports capable of 10, 100 or 1000Mbps auto-negotiation
operation (NWay), which means the switch could automatically
negotiate with the connected partners on the network speed and
duplex mode. It is ideal for micro-segmenting large networks into
smaller, connected subnets for improved performance, enabling the
bandwidth demanding multimedia and imaging applications. Moreover,
the 10/100/1000Mbps auto-sensing ability provides an easy way to
migrate 10/100Mbps to 1000Mbps network with no pain. Compared to
the shared 10Mbps or 100Mbps networks, the switch delivers a
dedicated 10/100/1000Mbps connection to every attached client with
no bandwidth congestion issue. This switch also supports auto MDI /
MDI-X function. Each port could be used to connect to another switch
or hub with no crossover RJ-45 cable.
Store-and-forward switching mode promises the low latency plus
eliminates all the network errors, including runt and CRC error packets.
To work under full-duplex mode, transmission and reception of the
frames can occur simultaneously without causing collisions as well as
double the network bandwidth.
The switch provides 9K bytes jumbo frames, which means the frames
size is larger than normal 1.5K. With the Jumbo frame function, you can
get better network performance, because the switch can send more
data at the same time.
The switch is plug-n-play without any software to configure and also
fully compliant with all kinds of network protocols.
Before you start to install the switch, check the following contents in this
package
One Gigabit Ethernet switch
One external power adapter
One Power Cord
User’s manual
2
Please refer to the following table for LED definition.
16-Port
24-Port
LED Status Operation
Steady Green Power is on
Power
Off Power is off
Steady Green Port Connected
Link/Act
Blinking Green The port is transmitting/receiving data
3
Connect each station to the switch by twisted-pair cable. Plug one
RJ-45 connector into a RJ-45 port of the switch, and plug the other
RJ-45 connector into the station’s network adapter. Power on the
switch and then system is ready.
For cable selection, refer to the following table.
In making a switch interconnection, you could use any port to connect
another switch with straight or crossover cable. As all the ports support
auto MDI / MDI-X function, using a straight cable to make a
switch-to-switch connection is allowed.
For cable selection, refer to the following table:
Network Speed Cable Type Max. Length
10Mbps Cat. 3, 4, 5 UTP/STP 100 meters
100Mbps Cat. 5 UTP/STP 100 meters
1000Mbps Cat. 5 UTP/STP 100 meters
4
Standard IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.3x full duplex operation and flow control
Interface 16/24* 10/100/1000Mbps RJ-45 Gigabit Ethernet Ports
Uplink
Auto MDI/MDI-XAuto crossover
Network
Speed
10/100/1000Mbps & Full/Half duplex mode auto
detection (1000Mbps for Full duplex only)
MAC Addr.
Table
8K MAC entries
Memory 500K bytes
Jumbo
Frame
9K bytes
Power
Supply
External Power adapter
12V 3A
EMI CE, FCC and VCCI class A
5
FCC Certifications
This Equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received; including interference that may cause undesired operation.
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55022 class A for ITE, the essential
protection requirement of Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to
electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may
be possible that information in this document is not up-to-date. Please
check with your local distributors for the latest information. No part of
this document can be copied or reproduced in any form without written
consent from the company.
Trademarks:
All trade names and trademarks are the properties of their respective
companies.
Copyright © 2008, All Rights Reserved.
9
Spezifikationen
Standards IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX
IEEE 802.3ab 1000BASE-T
IEEE 802.3x Full Duplex Operation und Flow
Control
Schnittstelle 16/24 * 10/100/1000Mbps RJ-45 Gigabit Ethernet
Ports
Uplink
Auto MDI/MDI-XAuto Crossover
Netzwerk
Datenrate
10/100/1000Mbps & Full/Half Duplex Mode Auto
Detection (1000Mbps nur bei Full Duplex)
MAC
Adressentabelle
8K MAC Einträge
Speicher 500K bytes
Jumbo Frame 9K bytes
Spannungs-
Versorgung
Externer Spannungsadapter
12V 3A
EMV CE FCC und VCCI Klasse A
31
English
"CE Mark Warning:
This is a Class A product. In a domestic enviroment this
product may cause radio interferences
in which case the user may be required to take adequate
measures."
German
"CE Zeichen Warnung:
Dies ist eine Einrichtung der Klasse A. Diese Einrichtung
kann im Wohnbereich Funkstörungen
verursachen; in diesem Fall kann vom Betreiber verlangt
werden, angemessene Massnahmen durchzuführen."
Spanish
“Advertencia de conformidad CE:
Este es un producto de Clase A. Este producto puede
causar interferencias en entornos domésticos lo cual
significa que se le podría requerir al usuario tomar las
medidas adecuadas.”
Français
"Avertissement de la conformité CE:
Ceci est un produit de la classe A. Dans un
environnement domestique ce produit peut occasionner
des interférences radio. Dans ce cas l'utilisateur peut être
amené à prendre des mesures adéquates."
Itaian
Avvertenza di conformità CE:
Questa è un apparecchiatura Classe A.
È probabile che l’ utilizzo di questa apparecchiatura in
ambienti
residenziali provochi interferenze pericolose, nel qual
caso l’utente dovrà correggere tali interferenze a proprie
spese.
Polish
CE Znak ostrzega:
To jest urządzenie klasy A. W obszarze domowym
urządzenie może wywoływać zakłócenia w radiofonii; w
takim przypadku użytkownik
może potrzebować odpowiednich pomiarów."
6
-
G21600
+
20P
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32

Longshine LCS-GS8116 User manual

Category
Network switches
Type
User manual
This manual is also suitable for

Longshine LCS-GS8116 is a powerful, high-performance Gigabit Ethernet switch featuring 16x 10/100/1000Mbps RJ-45 Gigabit Ethernet ports. It supports auto MDI/MDI-X function, allowing for easy and flexible switch-to-switch connections. The store-and-forward switching mode eliminates network errors and latency, while the 9K jumbo frame support enhances network performance. With its plug-and-play design, the switch is easy to install and configure without requiring any additional software.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI