USER GUIDE
HOME AND CAR POWER KIT
JUEGO DE CABLES DE CARGA DE HOGAR Y AUTO
TROUSSE D’ALIMENTATION POUR LA MAISON ET LA VOITURE
3
Piece Kit
English
Package contents................................................................ 1
Using the wall charger ........................................................... 2
Using the car charger ............................................................ 2
Charge/sync with included cable................................................. 2
Troubleshooting................................................................. 3
Technical specications.......................................................... 3
Warranty information............................................................ 4
Español
Contenido del paquete .......................................................... 5
Para usar el cargador de pared . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Para usar el cargador de auto ....................................................6
Carga y sincronización con el cable incluido ......................................6
Resolución de problemas ........................................................ 7
Especicaciones técnicas ........................................................ 7
Información de la garantía .......................................................8
Français
Contenu de l’emballage ......................................................... 9
Utilisation du chargeur mural ................................................... 10
Utilisation du chargeur pour la voiture .......................................... 10
Chargez/synchronisez en utilisant le câble fournis ............................... 10
Dépannage .................................................................... 11
Caractéristiques techniques..................................................... 11
Information sur la garantie...................................................... 12
“Made for iPod” means that an electronic accessory has been designed to connect specically to iPod and has
been certied by the developer to meet Apple performance standards.
“Works with iPhone” means that an electronic accessory has been designed to connect specically to iPhone
and has been certied by the developer to meet Apple performance standards. Apple is not responsible for the
operation of this device or its compliance with safety and regulatory standards.
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
iPhone is a trademark of Apple Inc.
All brands represented herein are registered trademarks of their respective manufacturers.
Todas las marcas representadas aquí son marcas comerciales registradas de sus fabricantes respectivos.
Toutes les marques représentées ici sont des marques déposées de leurs fabricants respectifs.
Thank you for purchasing the DigiPower Home and Car Power Kit for iPod and iPhone.
This product has been designed to provide fast charging times at home and on the go,
a high level of built in electronic safety features to protect your valuable equipment
from over voltage or short circuit conditions; all in a compact size, perfect for travel.
This kit includes:
| 1
USB 1A iPod/iPhone
certied wall charger
USB 1A iPod/iPhone
certied car charger
1 meter (3.3ft) USB
charge/sync cable
for iPod and iPhone
EnglishUSER GUIDE
1. Plug the wall charger directly into an AC outlet; the
blades are non-polarized so it will work correctly in
either direction.
2. Plug the USB connector into the wall charger and plug
the other end into your iPod/iPhone.
3. The battery indicator on your iPod/iPhone should now
show it is being charged. If it does not make sure the
outlet is getting power (there may be a switch that
controls the outlet).
1. Plug the car charger directly into your car’s CLA
(cigarette lighter adapter) or auxiliary power port.
2. The white LED on the front of the charger will glow to
indicate it is receiving power from your car.
3. Plug the USB connector directly into the car charger
and plug the other end into your iPod/iPhone.
4. The battery indicator on your iPod/iPhone should now
show it is being charged.
1. When the cable is connected from your iPod/iPhone to
your computer you will be able to charge the device
and simultaneously sync data such as phone contacts,
music, or pictures. Consult your device’s user manual
for exact sync capabilities.
| 2
1. If an over voltage condition occurs the unit will stop working to protect your
device. Unplug the charger, wait for 10 seconds then plug it back in. Continue to
use as normal.
1. If the fuse should trip, (LED goes o, device stops charging) unplug the charger
from the receptacle, make sure the receptacle is clean of any debris, wait 10
seconds, then plug it back in.
2. If the charger still does not function check your car’s fuse box to make sure that
fuse is in working condition (consult your car owner’s manual for location and type
of replacement fuse).
AC Voltage input range: 100-240V
Operating frequency 50Hz ~ 60Hz
Output voltage: 5V
Output Current: 1A
Over voltage protection
Short circuit protection
Input voltage range 12 to 16VDC
Output voltage: 5V
Output Current: 1A
Over voltage protection
Short circuit protection
Fuse type, electronic resettable.
| 3
Mizco’s responsibility with regard to this limited warranty shall be limited solely to the
repair or replacement at its option, of any product, which fails during normal consumer
use for a period of 1 Year from the date of purchase. This warranty does not extend
to damage or failure, which results from misuse, neglect, accident, alteration, abuse,
improper installation or maintenance. If at any time during the 1 Year period following
the purchase the product fails due to defects in materials or workmanship, return the
defective product with freight prepaid and proof of purchase.
All brands represented herein are registered trademarks of their respective
manufacturers. Design and specications are subject to change without notice.
Failure to read and follow these safety instructions could result in re, explosion,
electrical shock or other hazard, causing serious and/or fatal injury and/or property
damage.
• Donotmodify,disassemble,open,drop,crush,punctureorshredtheproduct.
• Donotexposetheproducttorainorwater.
• Thisproductisnotatoy.Keepawayfromchildren.Insurethatallpersonswho
use the product read and follow these warnings and instructions.
| 4
Gracias por adquirir el juego de cables de carga de hogar y auto para iPod y iPhone de
DigiPower. Este producto ha sido diseñado para tiempos rápidos de carga cuando esté
en casa o de viaje. Cuenta con un nivel alto de funciones de seguridad electrónicos
para proteger su equipo valioso contra condiciones de sobrecargas de voltaje o
cortacircuitos, todo en un tamaño compacto perfecto para viajes.
Este juego incluye:
| 5
Español
Cargador de auto USB 1A
certicado para iPod y iPhone
Cargador de pared USB 1A
certicado para iPod y iPhone
1 meter (3.3ft) USB
charge/sync cable
for iPod and iPhone
1. Conecte el cargador de pared directamente en una
salida de CA; las espigas no tienen polaridad, por lo
que funcionará bien sin importar en qué dirección que
lo conecta.
2. Enchufe el conector USB al cargador de pared y enchufe
el otro extremo en su iPod o iPhone.
3. El indicador de batería en su iPod o iPhone debe ahora
mostrar que se está cargando. Si no lo muestra,
asegúrese que la salida esté obteniendo corriente (podría
ser que haya un interruptor que controla la salida).
1. Conecte el cargador de auto directamente en el
adaptador del encendedor de cigarrillos o en el puerto
de corriente auxiliar.
2. La luz LED Blanca en el frente del cargador se encenderá
para indicar que está recibiendo corriente de su auto.
3. Enchufe el conector USB directamente al cargador del
auto y enchufe el otro extremo a su iPod o iPhone.
4. El indicador de la betería en su iPod o iPhone ahora
debe indicar que se está cargando.
1. Cuando el cable está conectado desde su iPod o
iPhone a su computadora, podrá cargar el dispositivo y
simultáneamente sincronizar la información, como sus
contactos telefónicos, música o fotografías.
| 6 | 7
1. Si ocurre una sobrecarga, la unidad dejará de trabajar para proteger su dispositivo.
Desconecte el cargador, espere unos 10 segundos y luego vuelva a conectarlo.
Continúe usándolo de manera normal.
1. Si el fusible se dispara (o sea, se apaga la luz LED y el dispositivo deja de cargar),
desconecte el cargador del receptáculo y asegúrese que el receptáculo esté
limpio, espere 10 segundos y luego vuelva a conectarlo.
2. Si el cargador aún no funciona, asegúrese que la caja del fusible de su auto esté
trabajando (consulte el manual del auto para encontrar la ubicación y el tipo de
fusible de reemplazo).
Entrada de voltaje AC: 100 - 240 V.
Frecuencia de operación: 50 Hz ~ 60 Hz
Voltaje de salida: 5 V
Corriente de salida: 1A
Protección contra sobrevoltaje
Protección contra cortocircuitos
Voltaje de entrada: 12 a 16 V CC
Voltaje de salida: 5 V
Corriente de salida: 1A
Protección contra sobrevoltaje
Protección contra cortocircuitos
Tipo de fusible, electrónico que se puede reestablecer
Page is loading ...
/
