2. Finder
  3. Tipo 1C.B1

Finder Tipo 1C.B1 User manual

  • Hello! I've analyzed the provided user manual for the finder 2nd GENERATION 1Y.GU.005.1 Wi-Fi Gateway. The document explains how to install and configure the device. It also details the different light indications of the device's luminous base, and its ability to control the Yesly system and Smart Bliss2 Thermostat. I'm ready to answer your questions about the device.
  • How do I configure the Gateway for YESLY?
    How do I configure the Gateway for Smart Bliss2 Thermostat?
    How to change the light intensity of the GATEWAY base?
    How to reset the device to factory settings?
Utility Model - IB1YGU0051VXX - 08/22 - Finder S.p.A. con unico socio - 10040 ALMESE (TO) - ITALY
2
3
1
1Y.GU.005.1
2nd GENERATION
ENGLISH
1Y.GU.005.1 GATEWAY 2
nd
GENERATION Wi-Fi 2.4 GHz - Radio 868 MHz
INSTALLATION
Connect the Micro USB connector to the Gateway and the power supply
to the electrical outlet.
After switching on, the Gateway’s luminous base will ash with a fading
white
light, awaiting conguration.
YESLY: Use the YESLY APP Finder to congure the Gateway, only after
creating the Yesly system with the TOOLBOX PLUS App Finder.
For more information: yesly.life/setup-gateway
SMART BLISS2 THERMOSTAT: Use the FINDER BLISS application to
congure the Gateway and the Smart Bliss2 Thermostat.
For more information: yesly.life/setup-bliss2
LUMINOUS BASE
WHITE LED
- Flashing fading: waiting for conguration
-
Fixed: connection established with both the Wi-Fi network and the Cloud
- 2 ashes: connected only to the Wi-Fi network - no connection to the
Cloud (internet not active)
- 3 ashes: no connection to the Wi-Fi network and no connection to
the Cloud (internet not active)
BLUE LED
Flashing: sending Bluetooth commands to the devices
RED LED
Flashing
: commands are sent to the Smart Bliss2 thermostat
GATEWAY SETTING
To change the light intensity of the GATEWAY base:
- press the button once: Low brightness
- press the button twice: Medium-Low brightness
- press the button 3 times: Medium-High brightness
- press the button 4 times: High brightness
RESET
Press the button for > 10 seconds to reset the settings to factory
1
2
3
YESLY BLISS2
/